User Manual

Page 23
HX400IS
6.9 PRIORITY SCAN
The Priority Scan is similar to the Memory Scan. However, the Priority Scan
monitors the Preset Channels, Scan Memory Channels and the Priority
Channel. The following channels can be set as the Priority channel: CH16,
CH9, or one of the Preset channel (default setting is CH16).
1. To set the priority channel, hold down the
key and press the
key. The channel will change from 16 to 09 to Preset channels 0
through 9 with each press of the key. When the
key is released the displayed channel will be set
as the priority channel (the “PRI” icon will appear
above of the channel number).
2. Press the key to start Scanning.
3. Press and hold the key to start Priority Scan, “
PSCAN
” will be shown
on the display.
4. When the HX400IS receives a transmission on a
working channel, it will stop on the working channel
and dual watch to the priority channel until the incom-
ing signal disappears, then start scanning again.
5. When the HX400IS receives a signal on the Priority channel it will stay
on this channel until the incoming signal disappears,
then start Priority scanning again.
6. To stop Priority Scanning, press the key.
“PRIORITy” SCAN
“MEMORy” SCAN
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel 4
Preset
Channel 5
Preset
Channel 0
Preset
Channel 1
Preset
Channel 2
Preset
Channel 3
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel 4
Preset
Channel 5
Priority Channel
Preset
Channel 0
Preset
Channel 1
Preset
Channel 2
Preset
Channel 3