User Manual
HX400IS
Page 26
7. MENU
(
“SET”
)
MODE
The Setup Menu allows a number of the HX400IS operating parameters to
be custom-congured for your operating requirements.
The Menu Mode is easy to activate and set, using the following procedure:
1. Turn the transceiver off by rotating the VOL knob fully counter-clockwise.
2. Hold down the
key, then turn on the transceiver while still holding
down the key.
3. The Menu item will scroll on the upper left corner of the display and its
current status or value will appear on the large display.
4. Press the or key to select the Menu item to be adjusted.
5. Press the
key to enable adjustment of the selected Menu item. The
current status or value will blink.
6. Press the
or key to select the desired status or value of the Menu
item.
7. After completing your adjustment, press the key to save the new set-
ting.
8. If you wish to change another Menu item, repeat steps 4 to 7 above.
9. Press the key to exit to normal operation.
BEEP LEVEL
Function: Enables/Disables the Keypad beep.
Available Values: HI / Lo / oFF
Default: HI
LAMP MODE
Function: Selects the Lamp illumination method for the
LCD/Keypad.
Available Values: KEY / Cnt (Continuous) / oFF
Default: KEY
KEY: Illuminates the LCD/Keypad for 5 sec-
onds when any key is pressed.
Cnt (Continuous): Illuminates the LCD/Keypad continuously.
oFF: Turns off the backlight for the LCD and keys.
SCAN LAMP
Function: Enables/Disables the Lamp while scanner is
paused.
Available Values: on / oFF
Default: on