Operation Manual

GX3000SPage 36
THIS NUMBER MUST BE PROGRAMMED INTO THE RADIO TO OPERATE
THE GX3000S DSC FUCTIONS.
How can I obtain an MMSI assignment?
In the USA, visit the following websites to register:
http://www.boatus.com/mmsi/ or
http://seatow.com/boating_safety/mmsi.asp
In the Canada, visit
http://www.ic.gc.ca/epic/site/smt-gst.nsf/en/sf01032e.html or
http://www.usps.org/php/mmsi/rules.php
11.2.2 Programming the MMSI
WARNING
User MMSI can be input only ONEC. Please be careful not to input
the incorrect MMSI number. If you try to enter the MMSI more than
one time, the radio will show the display on the
right. If the MMSI number has been entered in-
correctly, the transceiver will have to be sent to
Factory Service. Refer to the section “15.2. FAC-
TORY SERVICE.”
1. Press and hold down the
[
CALL
(
MENU
)]
key until
the “
Radio SetupRadio Setup
Radio SetupRadio Setup
Radio Setup” menu appears.
2. Turn the CHANNEL selector knob to the left to se-
lect “
DSC SetupDSC Setup
DSC SetupDSC Setup
DSC Setup” menu.
3. Press the
[
ENT
]
key, then select “
User MMSIUser MMSI
User MMSIUser MMSI
User MMSI” with
the CHANNEL selector knob.
4. Press the
[
ENT
]
key. The display will show a series
of dashes or the last MMSI number if programmed.
5. Turn the CHANNEL selector knob or press the
[
UP
(
S
)]
/
[
DOWN
(
T
)]
key on the microphone to se-
lect the first number of your MMSI, then press the
[
ENT
]
key to step to the next number.
6. Repeat step 5 to set your MMSI (up to nine digits).
7. When finished programming the number, press and
hold the
[
ENT
]
key to store the number in memory.
8. To exit this menu and return to radio operation mode
press the
[
16/9
]
key.