User's Manual

76
VIBRATOR CHARGING
• Wash and fully dry your We-Vibe 4 before
recharging it.
• Plug the USB cable into a USB power adapter (not
included) or USB port. Any USB power adapter can
be used for charging.
• When a computer USB port is used, the We-Vibe will
not charge if your computer goes into hibernation
mode.
• When the We-Vibe 4 is correctly placed in its
charging base connected to a power source, the
LED on the front of the charging base blinks to
indicate that the device is charging.
• A full charge takes up to 6 hours, depending on the
charge remaining in the We-Vibe 4.
• The We-Vibe 4 operates for up to 3 hours on a full
charge, depending on the vibration mode. Modes
with higher vibration speeds will drain the battery
faster.
• There’s no need to drain the battery before
recharging.
• If you store your We-Vibe 4 o the charging
base, the charge is maintained for several months
but will continually diminish over time. For best
performance and long battery life, recharge before
vibrations weaken noticeably.
• If you use it regularly, we recommend storing your
We-Vibe 4 on the charging base and plugged in.
• Your We-Vibe 4 will not charge if it is too hot
(+45 °C). The LED on the charger will blink once
every 5 seconds until the temperature reaches
a safe level. At that point, charging will begin
automatically.
CLEANING AND STORAGE
• Clean with gentle soap and water before and after
every use.
• Store on the charging base with the lid on.
• Keep away from extreme heat or cold.
DO NOT
• Do not overextend the flex arm or
twist it into an unnatural shape.
• Do not use with silicone-based lubricants because
they will damage the product. For more information
on lubricants, visit we-vibe.com/lubes.
• Do not clean with products that contain alcohol,
petrol or acetone.
• Do not boil, bake, microwave or put the We-Vibe 4
or the charging base in a dishwasher.
• Do not store in extreme temperatures.
• Do not use a USB hub that is also charging other
devices.
PRODUCT SPECIFICATIONS
• We-Vibe 4 battery: Lithium ion
• Run time: Up to 3 hours
• Charging: USB
• Materials: Medical-grade silicone
• Charging time: Up to 6 hours
• Remote control battery: Replaceable lithium coin
cell (CR2032)
To sync the remote control with the We-Vibe 4
vibrator:
• Press the control button on the We-Vibe 4 to turn
it on.
• Press and hold any button on the remote control and
hold it next to the We-Vibe 4 for a few seconds.
• The light on the remote control will blink 3 times
when it has paired with the We-Vibe 4.
• It operates within 3 metres (10 feet) of the
We-Vibe 4.
• It remains on standby for 45 minutes after the
We-Vibe 4 is turned o. After 45 minutes, use the
control button on the We-Vibe 4 to restart the
vibrator and activate the remote control.
• It is water resistant, but do not submerge it in water.
If water gets inside, open it, remove the battery,
and drain any water. After the remote control
dries out, replace the battery, close the case,
and start using it again.
• To replace the battery, remove the battery cover
from the back of the remote control. Replace the
old battery with a new lithium coin cell (CR2032)
battery. Put the battery cover back on.
ABOUT THE REMOTE CONTROL
Unclip latch and rotate open
Battery door
Back of Remote
Battery door latch