User Manual

GX2000/GX2150Page 24
7 CONTROLS AND INDICATORS
NOTE
This section defines each control of the transceiver. See illustration at
the next page for location of controls. For detailed operating instructions
refer to chapter 8 of this manual.
7.1 FRONT PANEL
CHANNEL Knob
Rotary knob is used to select channels and to choose menu items (such
as the DSC menu, Radio Setup and DSC Setup menu). The / keys
on the microphone can also be used to select channels and menu items.
SECONDARY USE
 Press this knob to enter a selection in the “SETUP MENU” or “DSC
MENU”.
 While holding down the soft key and turning this knob, you can
confirm memory channels that have been programmed for scanning.
 When in the PA or Fog mode, turning this knob changes the output vol-
ume of the connected horn speaker.
PWR/VOL Knob
(
Power Switch / Volume Control
)
Turns the transceiver on and off as well as adjusts the speaker volume.
To turn the transceiver on, press and hold this knob until the radio turns on.
When the power is turned on, the transceiver is set to the last selected
channel. Clockwise rotation of this knob increases the internal and speaker
microphone volume.
To turn the transceiver off, press and hold this knob until the radio turns off.
SECONDARY USE
When in PA or Fog mode, controls the listen back volume (GX2150 only).