Instructions / Assembly

The Curve Grab Bar

Assembly Instructions:

FIGURE 1 FIGURE 2

ITEM LIST:

1. Curved Handle

2. Base Mount (Has a hole through tube)

3. Top Mount (No hole through tube)

4. Horizontal Mount

5. Cover Cap (Quantity 3)

6. Pivot Bushing

7. Washer

8. Socket Head Screw

9. Wood Screws (Quantity 10) 2 Extra

10. Allen Head Wrench (not shown)

STEP 1:

Take all items out of the box and lay them on a flat surface as shown in Figure 1.

Put Cover Caps (Item-5) on Items 2, 3, and 4 as shown in Figure 1.

STEP 2:

Insert the Base Mount (Item-2) into the Curved Handle (Item-1) and align the holes to insert Socket

Head Screw (Item-8).

Insert the Socket Head Screw (Item-8) into the Washer (Item-7) and insert the Socket Head Screw

through the aligned holes of the Curved Handle (Item-1) and Base Mount (Item-2).

STEP 3:

Align Horizontal Mount (Item-4) with the Socket Head Screw (Item-8) and use the included Allen Head

Wrench to tighten the Socket Head Screw into the threaded end of the Horizontal Mount (Item-4).

Note: The threaded end of the Horizontal Mount (Item-4) is located on the inside of the

Horizontal Mount tube. Make sure the Socket Head Screw is aligned before tightening.

If the Socket Head Screw is not aligned, you can damage the threaded end of the

Horizontal Mount (Item-4).

STEP 4:

Before inserting the Top Mount (Item-3) into the Curved Handle (Item-1), slide the Pivot Bushing (Item-

6) onto Top Mount (Item-3).

Note: The Pivot Bushing (Item-6) has a large radius (rounded) edge on one side. Slide the large

radius (rounded) side on first.

PAGE 1
The Curve Grab Bar Assembly Instructions: FIGURE 1 FIGURE 2 ITEM LIST: 1. 2. 3. 4. 5. Curved Handle Base Mount (Has a hole through tube) Top Mount (No hole through tube) Horizontal Mount Cover Cap (Quantity 3) 6. 7. 8. 9. 10. Pivot Bushing Washer Socket Head Screw Wood Screws (Quantity 10) 2 Extra Allen Head Wrench (not shown) STEP 1: Take all items out of the box and lay them on a flat surface as shown in Figure 1. Put Cover Caps (Item-5) on Items 2, 3, and 4 as shown in Figure 1.
PAGE 2
STEP 5: Determine the location that you would like to install the Curve Grab Bar. Once you have determined the location, you will need to locate the studs behind the wall. The studs are the rectangular shaped wood structures that support the wall. The studs are perpendicular to the floor and the studs are spaced 16 inches apart behind the wall. It is important that all 8 wood screws are securely fastened into the studs. There are several options used to locate the studs behind the wall. • Use a magnet.
PAGE 3
WARNING: Please read before using this product. 1. Serious injury or death can result if the Curve Grab Bar is not properly installed. Standers Inc. is committed to providing safe products and informing the user of ways to prevent accidents. SAFETY PRECAUTIONS: Regularly check the Curve Grab Bar to make sure it is tightly secured to the wall. The Curve Grab Bar uses a spring loaded pin that allows the handle to rotate and lock into several user positions.