User's Manual

10
English
DO NOT use in presence of flammable liquids or gases. The camera
cable extension is waterproof up to the camera connector. DO NOT
USE the handle set under wet conditions.
The inspection camera is a professional tool. DO NOT let children
come into contact with the tool. Supervision is required when
inexperienced operators use this tool.
ASSEMBLY
Screen (Fig. 4)
FIG. 4
E
G
When the screen is attached to the
handle set with a battery, it will receive
a charge from the battery. Ensure the
screen is fully charged before use.
When the screen is disengaged from
the handle set, a battery icon appears
in the upper left corner. This icon
also displays the current charge of the
screen.
To install the screen (E) into the handle
set (G), align the screen with the rails
on the handle set and slide it firmly into
the handle until you hear the lock snap
into place.
To remove the screen from the handle
set, firmly slide the screen up from the
tool handle.
The screen can be turned on and viewed when it is not attached to the
handle set, allowing easier maneuverability of the camera.
Camera Cable (Fig. 5)
Align the camera cable with the camera connector (D). Push in and
turn the connector counterclockwise (camera screen facing you) to
firmly attach.
D
FIG. 5
To remove the camera cable, turn the connector clockwise (direction
of arrow).
Additional camera cable and extensions are available at additional
cost. Please contact D
e
WALT Industrial Tool Co., 701 East Joppa
Road, Towson, MD 21286, call 1-800-4-D
e
WALT (1-800-433-9258)
or visit our website www.dewalt.com.
Hook and Magnet DCT410 (Fig.6)
The hook is beneficial for retrieving cable or wire located in tight
spaces. The magnet is beneficial for retrieving metal objects in tight
spaces.
To attach the hook or magnet, turn the knurled part of the camera
counterclockwise until it stops.
Align the hook or magnet with the gray groove (T) then slide it down
until the tabs (U) at the top of the hook/magnet are securely in the
notches (V) located in the camera lens.
Turn the knurled part clockwise to lock the base of the hook and
magnet.