User's Manual

Install Door Hardware (Task 9)

This section provides general instructions for installing your controllers. Complete

instructions for installing locks are packaged with the hardware. You will also

ﬁnd instructions for Stanley Wi-Q Technology Best 45HQ mortise locks, Best 9KQ

Cylindrical Locks, Best EXQ Trim, Omnilock 45KOM mortise locks, and Omnilock

9KOM cylindrical locks as Appendices to this manual.

Before You Begin

Before you begin, take a few moments to review the following consider-

ations:

 Record device MAC address before installing device. You will need this when

conﬁguring the controller in the software.

 Wi-Q and Omnilock Technology locks will work from -31°F to 151°F.

Note Extreme heat will cause a reduction in wireless signal strength and can cause a

loss of connectivity while the heat remains.

Note Alkaline batteries cease to operate if they reach a temperature of -20°F.

 Wi-Q and Omnilock Controllers are designed for use on 1-3/4-inch doors. If you

need to install on non-standard doors, contact Stanley Customer Service for

more information.

 Lockset instructions are given for right-hand doors (as determined from outside

the door). If you are installing a left-hand door, see the instructions provided

with your lockset for hand change instructions.

 If you are installing locksets on unprepared (un-drilled) doors, use the template

provided with your speciﬁc lockset.

Please refer to the Appendices or the instructions provided with your particular

lock to complete these steps. Once this is done, check controller operation as

described in the following paragraphs.