User's Manual

Chapter 3: First-time B.A.S.I.S.® Offline System Configuration
3 – 3
Notes
Installing the encoder
Two types of encoders are available for the B.A.S.I.S. Offline
system:
■ Magnetic stripe encoder
Unitech model MSR206
part number MSR206-33
■ Smart card encoder
GemPlus model GEMPC410
part number GCR410-P
BEST part number 1825235
For proper setup of the smart card encoder, contact
your BEST Representative.
The card encoder or some type of encoding device (that is, an
encoder or a printer with a built-in encoder) is required for
B.A.S.I.S. G locks. So the following instructions are required
for B.A.S.I.S. G functionality, but optional for B.A.S.I.S. V. For
a comparison of B.A.S.I.S. G and V, See “Feature comparison
of B.A.S.I.S. G and B.A.S.I.S. V” on page 2-7.
These instructions assume a stand-alone encoder.
To set up the encoder
1 Click Start > Programs > B.A.S.I.S. ET > System
Administration.
2 At the login window type your user name and password
and then click OK. 
If you do not know your user name or password, see your
System Administrator.
3 Click Administration > Workstations.
4 From the Workstation tab, confirm that the name of your
computer is in the list. If your computer is not in the list,
add your workstation by using the browse button and
select your workstation.
5 Click Add.
6 Type the name of your computer or click the browse
button and browse the network for your computer.
7 Click OK.
8 Click the Encoder tab.
9 Confirm that the encoder is physically connected to a COM
port on the computer, preferably COM1, and is powered
on.