User's Manual

Chapter 4: Setting up and Maintaining B.A.S.I.S.® Offline Locks
4 – 20
Notes
Clearing the diagnostics code
The lock’s diagnostics code indicates firmware conditions,
such as firmware resets, that have occurred at the lock since
the diagnostics code was last cleared. For more information,
see page 4-15.
To clear a lock’s diagnostics code, perform these steps:
1 If you are already viewing diagnostics information for the
lock, go to Step 2.
If you are not viewing diagnostics information for the lock,
perform Step 1 through Step 7 on page 4-16.
2 From the B.A.S.I.S. Transport Diagnostics window on the
PDA (Figure 4.11 on page 4-14), tap Diagnostics, then
Reset, then Diagnostics Code.
A confirmation message appears asking, “Reset
diagnostics code?”
3 Select OK.
The diagnostics code is reset to 0x0000.
4 When you have finished using diagnostics features,
perform Step 8 through Step 10 on page 4-16.