User's Manual

USER’S GUIDE- 5
WIRELESS ACCESS MANAGEMENT SYSTEM
FCC Certification
This equipment has been tested and found to comply with the limits for Class B Digital Device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, you can try to correct the interference by taking one or more of the
following measures.
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
• Consult the dealer or an experienced radio/TV technician for help.
Approved Antennas
• Portal Gateway :
Antenna Factor ANT-2.4-CW-RCT-xx
• WXC:
Southwest Antennas PN 1055-036
This device has been designed to operate with a maximum gain of 5
dBi. Approved antennas
are listed below. Antennas not included in this list or having a gain greater than 5 dBi are
strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
• WAC /Single Door Controller:
Antenna Factor ANT-2.4-CW-RCT-xx
This device has been designed to operate with a maximum gain of 2.2
dBi. Approved
antennas are listed below. Antennas not included in this list or having a gain greater than 2.2
dBi are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. The antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provided with antenna installation and transmitter operating
conditions for satisfying RF exposure compliance.
SOFTWARE OVERVIEW
The STANLEY Wireless Access Management Solution (WAMS) provides powerful tools to
manage your system: WAMS Configurator, WAMS Transactions, WAMS Statistics Monitor.
View and print reports from WAMS Configurator and WAMS Transactions using WAMS Reports.