Replacement Part List

36BS, 36BDS
6
Rev: Mar2011
STANLEY
®
Brush Mower

A. Aach handle bars using the upper hole
posion seng. Using this hole posion sets
the handle bars several inches lower. Use the
lower hole posion raising the handle bar
locaon by several inches for comfort, if
necessary. These hole posions can also be
used for adjusng the handle bar locaon for
operators of dierent heights and arm lengths.
Select the height that is most comfortable for
you.
B. Reconnect the four (4) connecng rods from
the control panel to the chassis pivot points as
shown in the picture to the right. The rod
connecons are secured with an inial preset
for the upper hole posion (lower handle bar
posion). If the lower hole posion (upper
handle bar posion) is used, the rod
connecons must be adjusted.
C. Should the pivot ends on the connecng rods
be rotated during assembly, minor
adjustments may be required to achieve full
travel on each control handle. 


--
. This posioning
provides full forward speed and the correct
restricted speed in reverse. Make minor
adjustments to the posion of the threaded
connecng rod aachment to achieve this
control posioning.


-
