Replacement Part List

36BS, 36BDS
13
Rev: Mar2011
STANLEY
®
Brush Mower


Regular maintenance is essenal to ensure your brush
mower connues to deliver safe and high-quality
performance.
To help you properly care for your brush mower, the
following pages include a recommended maintenance
schedule, roune inspecon procedures, and simple
maintenance procedures using basic hand tools.
Maintenance is the responsibility of the owner and
must be performed regularly. More dicult service
tasks or tasks that require special tools are best
handled by a recommended service technician or other
qualied mechanic.
The maintenance schedule described on page 15
applies to mowers used under normal operang
condions. If you operate your brush mower under
severe condions, such as sustained prolonged use or
high-temperature operaons, or use it in unusually
wet, dusty or rocky condions, consult your servicing
dealer for recommendaons applicable to your
individual needs and use.
Be sure to use genuine STANLEY mower replacement
parts when servicing your mower to assure the best
quality, safety and performance.

---
Before making any adjustments and/or
servicing to your STANLEY mower, make sure the
mower is on a level surface, with the ignion switch
o, the key removed, and the blades disengaged. Also,
disconnect the spark plug wires from the spark plugs
and ground them against the engine to prevent
inadvertent starng.
If you are performing adjustments or maintenance
aer operang the mower, allow the unit to cool since
heat build up could cause severe burns.

Incorrect re pressure may cause the mower to pull to
one side and/or result in uneven cut. Use cauon when
lling the res. NEVER exceed the recommended 24
PSI.

Refer to the Engine Owner’s Manual for the









Refer to the Engine Owner’s Manual for the type of
fuel to use.
A fuel shut o valve is located on
the boom of the fuel tank. It is
recommended that the fuel be
shut o when transporng
between job sites and when
storing the mower for extended
periods of me.

CHECK ENGINE OIL BEFORE EACH USE. Refer to the
Engine Owner’s Manual for the type of oil to use, oil
change intervals, and the proper procedures to check
and change oil.

Inspect blades on a daily basis for nicks, bends, and
excessive wear. If the blades are worn, cracked, bent,
or damaged, replace them before using the mower.
Choose genuine STANLEY mower replacement blades
to ensure quality and performance. (See page 12 for
blade removal instrucons.)
When sharpening the blades, sharpen only the cung
edges and try to maintain the original angle of the
blade. Do not make the cung edge razor sharp.
Remove the same amount from each side of the blade
so that balance in maintained.







