Use and Care Manual

36BS, 36BDS
7
Rev: Mar2011
STANLEY
®
Brush Mower


The pre-wired handle bar assembly has a total of
four (4) connecons. Route the wire harness as
shown in the top right photo and make the following
connecons indened by number in the other
photos:
1. Route the smaller, white, 2-pin connector
through a hole in the chassis and connect it to
the blade acvaon safety switch 2-pin
connector.
2. Connect the larger, 5-pin connector to the
mang connector at the rear of the engine.
3. Connect the black wire to a ground lug located
on the back or side of the engine.
4. If equipped, aach the yellow wire to the boom
of the starter motor solenoid on the engine, with
the posive (red) baery cable.
Aach the posive (red) and ground (black) baery
terminal wires to the baery to provide power to the
electric starter.
Baery ground should be to the engine block.
Once all connecons are made, use the provided
black wire-es to strap the wire harness into place
permanently to the handle bars and chassis.

The throle and choke are shown in the adjacent
photo. See instrucons for connecng them to the
engine in the Engine Owner’s Manual provided.

Throl
Choke