Use and Care Manual
36BS, 36BDS
17
Rev: Mar2011
STANLEY
®
Brush Mower
To ensure proper lubricaon of moving parts, GXi recommends that you lubricate the following components with a
high-quality, EP2 high-temperature-based grease or equivalent. Should the condions of operaon be more severe
than normal, the lubricaon interval may need to be shortened. GTR/OPE grease is the recommended lubricant.
STANLEY mowers have four (4) lubricaon points.
The brush mower spindle bearings are both
sealed top and boom to prevent contaminants from
entering the spindle. There is no service point on the
spindle.
Mower deck idler pulley
brackets (1 locaon)
2. Blade acvaon rod supports (2 locaons: one at
the support under the fuel tank bracket and one
adjacent to the engine.)
3. Hydraulic drive system idler puller support (1
locaon)
Be sure the hydro unit is disengaged (see page
11) before interchanging the oponal aachment deck.
1. Remove the deck cover
by releasing the three
(3) T-handles.
2. Disconnect the
clutch tension rod
connecng the deck
to the chassis.
3. Remove the belt from
the engine pulley.
4. Using an 18 mm
wrench or socket,
remove the four (4)
deck retaining bolts.
5. Tilt handle bars forward and pull chassis from deck.
6. Reverse the steps to reconnect the oponal
aachment deck. Refer to the owner manual
supplied with the oponal deck for assembly and
operaon instrucons.