Product Manual

19 - ENG
NOZZLE CLEANING (FIG. 14)
If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure
may develop. If the nozzle becomes partially clogged or restricted, the pump pressure
will pulsate. Clean the nozzle immediately using the nozzle kit supplied and the
following instructions:
1. Shut off the pressure washer and turn off the watersupply.
2. Pull trigger on gun handle to relieve any waterpressure.
3. Disconnect the spray wand from thegun.
4. Remove the high pressure nozzle (K) from the spray wand.
14
K
K
N
Remove any obstructions with the nozzle cleaning tool
provided and backflush with cleanwater.
5. Direct water supply (N) into nozzle to backflush loosened
particles for 30seconds.
6. Reassemble the nozzle to the wand.
7. Reconnect spray wand to gun and turn on watersupply.
8. Start pressure washer and place spray wand into high
pressure setting totest.
CLEAN THE WATER INLET FILTER (FIG. 10)
This screen filter should be checked periodically and cleaned if necessary.
1. Remove filter by grasping end and removing it from water inlet of pump.
2. Clean filter by flushing it with water on bothsides.
3. Re-insert filter into water inlet of pump. NOTE: Cone side facesout.
NOTE: Do not operate the pressure washer without filter properly installed.
STORAGE
ENGINE
Consult the Engine Owners Manual for manufacturer’s recommendations
forstorage.
TO PREVENT FUEL-RELATED PROBLEMS
1. Add Ethanol Shield
TM
fuel stabilizer following the manufacturer’s instructions. When
adding a gasoline stabilizer, fill the fuel tank with fresh gasoline. If only partially
filled, air in the tank will promote fuel deterioration during storage. If you keep a
container of gasoline for refueling, be sure that it contains only freshgasoline.
2. After adding a gasoline stabilizer, run the engine outdoors for 10 minutes to be sure
that treated gasoline has replaced the untreated gasoline in thecarburetor.
3. Turn the fuel valve to the OFFposition.
4. Continue to run the engine until it stops from the lack of fuel in the carburetor fuel
bowl. Running time should be less than 3minutes.
PUMP
The manufacturer recommends using SIMPSON
®
/ POWERWASHER
®
Pump Guard
or equivalent when storing the unit for more than 30 days and/or when freezing tem-
peratures are expected. SIMPSON
®
/ POWERWASHER
®
Pump Guard is environmen-
tallyfriendly.
NOTE: Using pump guard helps provide proper lubrication to the internal seals of the
pump regardless of temperature or environment.
Job Name: 31925 FNA STANLEY 7108823 MANUAL
PDF Page: SXPW3124_2823 pw manual 7108823 rev 0 03142017.p19.pdf
Process Plan
: Tabloid Pdf Proof HI-RES - NO TRIM LINES
Date: 17-03-14
Time: 14:59:44
Operator: ____________________________
PageMark-BW-Comp
OK to proceed
Make corrections and proceed
Make corrections and show another proof
Signed: ___________________ Date: ______
Job Name: 31925 FNA STANLEY 7108823 MANUAL
PDF Page: SXPW3124_2823 pw manual 7108823 rev 0 03142017_DBL.p19.pdf
Process Plan
: Tabloid Pdf Proof HI-RES With TRIM LINES
Date: 17-03-14
Time: 15:03:14
Operator: ____________________________
PageMark-BW-Comp
OK to proceed
Make corrections and proceed
Make corrections and show another proof
Signed: ___________________ Date: ______