Product Manual

ManualsBrandsStanley ManualsGas2800 PSI (Gas - Cold Water) Pressure Washer

8- ENG

QUICK SETUP GUIDE

DANGER: To reduce the risk of injury, read the pressure washer instruction manual

and the engine instruction manual before operating pressurewasher.

Install the

Handle

Place handle

onto frame, depress the

snap buttons, and slide

the handle assembly

onto the frame until snap

buttons snap intoplace.

Add/Check Oil

The engine is

shipped without

oil. Before starting engine,

add the oil. Check

oil level prior to each

use. Refer to Engine

Owner’s Manual for

completeprocedure.

Add Gasoline

In a well ventilated

outdoor area

add fresh, high quality,

unleaded gasoline with

a pump octane rating

of 86 or higher. Do not

overfill. Wipe up spilled

fuel before starting the

engine. Refer to Engine

Owner’s Manual for

completeprocedure.

IMPORTANT: Ethanol Shield

(sold separately) is a fuel stabilizer that helps eliminate

and prevent ethanol related problems in power equipment. Follow the instructions on the

container and add to the gasoline.

Wheel Installation

Slide the axle pin through the wheel and one of the flat washers. Slide the axle pin

through the hole in the frame and other flat washer. Slide clip through hole in axle pin

to secure wheel in place. Repeat same steps for second wheel.

NOTICE: Keep machine level during wheel installation process.

Do not tilt, tip over, or turn upside down to install wheel kit. May

causedamage!

Job Name: 31925 FNA STANLEY 7108823 MANUAL

PDF Page: SXPW3124_2823 pw manual 7108823 rev 0 03142017.p8.pdf

Process Plan

: Tabloid Pdf Proof HI-RES - NO TRIM LINES

Date: 17-03-14

Time: 14:59:44

Operator: ____________________________

PageMark-BW-Comp

❏ OK to proceed

❏ Make corrections and proceed

❏ Make corrections and show another proof

Signed: ___________________ Date: ______