User Manual

2. SPECIFICATIONS
2.1 INTENT OF USE
The 71501 Module is principally a piston and cylinder assembly. When coupled hydraulically to a compatible hydraulic
power source and the relevant nose assembly is attached, it is then used to install blind rivets up to 6.4mm (1/4”) in
diameter, in Industrial Environments.
The placing module may only be used in accordance with the operating instructions for placing Stanley Engineered
Fastening structural rivets.
DO NOT use under wet conditions or in the presence of ammable liquids or gases.
The safety instructions must be followed at all times.
2.2 TOOL SPECIFICATION
SPECIFICATION METRIC IMPERIAL
Force: Pull at stated pull pressure 12.9 kN 2900 lbf
Pressure: Maximum 345 bar 5000 PSI
Stroke: Piston Stroke 31.75 mm 1.25 in
Piston Bore Diameter: Minimum 4.87 mm 0.19 in
Weight: Without nose equipment 0.77 kg 1.70 lbs
2.3 TOOL DIMENSIONS
All dimensions are shown in millimetres.
7
ORIGINAL INSTRUCTION ENGLISH