User Manual

10 11
OPERATING INSTRUCTIONS
Unpacking
Carefully unpack your air compressor. This air compressor is bulky and
heavy, two (2) person lift required. Dispose of all packing material in an
environmentally responsible manner.
Assembly
Your air compressor requires minor assembly before initial operation.
Check that you have all required components required for assembly and
initial use.
Your compressor is filled with oil do not tip to assemble.
Oil breather
This compressor already has the oil breather fitted. It is closest to the
pressure switch, this is also the oil fill.
Lubrication
Warning: Your air compressor IS FILLED with OIL!
To check the oil level:
1. Always check the oil level when the air compressor is on flat and
level ground.
Look at the sight glass and ensure the oil is above the red dot on the
sight glass, as per the “OIL LEVEL GAUGE” label, see Pic. 3 and Pic. 4.
To add oil, if required, additional oil not included:
1. Remove oil breather.
2. Add oil, SAE30 to at least the top of the red dot,
see Pic. 4.
3. Oil level will take about 1 minute to drain down
and settle.
4. Check oil level in sight glass, see Pic. 3.
Re-check and top up if required, until level is correct.
5. Replace oil breather.
WARNING
Do not attempt to operate this compressor until it is fully
assembled.
Damage caused due to incomplete assembly will not be covered
under warranty.
Ensure the air compressor is disconnected from the power
supply before carrying out any assembly, maintenance or
adjustments on the machine.
Never under fill or over fill with oil.
PIC. 2
Oil breather
PIC. 3
Oil level should be
to the top of the
red dot on the sight
glass
as per the label
Oil breather
Oil sight glass
PIC. 4