5 8 3 4 2 1 9 7 6 www.stanley.eu FMC626 Downloaded from www.Manualslib.
(Original instructions) ENGLISH A B 3 2 1 D C 3 4 E 2 Downloaded from www.Manualslib.
(Original instructions) Intended use Your Stanley Fat Max FMC626 drill/screwdriver has been designed for screwdriving applications and for drilling in wood, metal, plastics and soft masonry. This appliance is intended for professional and private, non professional users.. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury.
ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
(Original instructions) Warning! The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. The vibration level may increase above the level stated.
ENGLISH (Original instructions) The green LED will flash indicating that the battery is being charged. When the charger is used with some portable power sources such as generators or sources that convert DC to AC, the charger may temporarily suspend operation. The LED flashes in the pattern indicated on the label. This indicates that the power source is out of limits. Leaving the battery in the charger The completion of charge is indicated by the green LED remaining on continuously.
(Original instructions) To remove battery pack u Depress the battery release button (7) as shown in figure B and pull battery pack out of tool. Trigger switch & forward/reverse button - figure C u u u u u The drill is turned ON and OFF by pulling and releasing the trigger switch (1) shown in figure C. The farther the trigger is depressed, the higher the speed of the drill. A forward/reverse control button (2) determines the rotational direction of the tool and also serves as a lock off button.
(Original instructions) ENGLISH Drilling in metal Maintenance Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which should be drilled dry. The cutting lubricants that work best are sulphurized cutting oil. Your Stanley Fat Max tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
(Original instructions) Battery FMC685L FMC687L FMC684L Voltage VAC 18 18 18 Capacity Ah 1.5 2.0 1.3 Li-Ion Li-Ion Li-Ion Type ENGLISH The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Stanley Fat Max. Level of sound pressure according to EN 60745: Sound pressure (LpA) 87.0 dB(A), uncertainty (K) 3 dB(A) Sound power (LWA) 98.
ENGLISH (Original instructions) 10 Downloaded from www.Manualslib.
(Original instructions) ENGLISH 11 Downloaded from www.Manualslib.
United Kingdom Stanley Fat Max 210 Bath Road Slough, Berkshire SL1 3YD 90633828 REV-0 Downloaded from www.Manualslib.com manuals search engine Tel. 01753 511234 Fax 01753 572112 www.stanleytools.co.
