Operation Manual
User Manual
GB
Checking the vertical (plumb) calibration of the
laser can be most accurately done when there is
30' (9m), with one person on the floor positioning
the position of the beam. It is important to conduct
the distance of the applications for which the tool
will be used.
Place the laser on the floor and turn on both
vertical beams.
2.
Mark position (f) where the beams cross on the
floor position, also marking position (g) on the floor
and also marking where the beams cross on the
ceiling (h). Always mark the center of the beams’
thickness.
3.
the beam crossing is exactly on the original marks
(f,g) on the floor.
4.
Mark the position where the beams cross on the
ceiling (j).
Measure the distance between the two ceiling
marks (h, j). If the measurement is greater than the
values shown below, the laser must be serviced at
an authorized service center.
Distance
Between Walls
Allowable Distance
Between Marks
30' (9.0m)
BEAMS (FIG. H)
Checking 90º accuracy requires an open floor area at
position of the laser at each step and for the location
of the marks made at each step. Always mark the
center of the beams’ thickness.
Set up the laser in one corner of the floor and turn
on the side vertical beam.
2.
Mark the center of the beam at three locations
(a, b and c) on the floor along the laser line. Mark
3.
Move the laser to mark b and turn on both vertical
beams.
4.
Position the beam crossing precisely at mark b,
Rotate the laser over mark b so that the side
vertical beam now passes through mark d.
7.
Mark the location (e) where the side vertical beam
passes by mark a.
the measurement is greater than the values shown
below, the laser must be serviced at an authorized
service center.
Distance
Allowable Distance
Between Marks
23' (7.0m)