Operation Manual
7
• Please read all related instructions and warnings
in the accompanying Battery Safety and Laser
regulations for disposal of the product at the
end of its life.
Safety
SAVE THESE INSTRUCTIONS:
Before using the power supply, read all safety
instructions and cautionary markings on power supply,
and product before using your power supply.
WARNING: Shock hazard. Do not allow any
liquid to get inside power supply. Electric shock
may result.
CAUTION: Burn hazard.
• NOTICE: Under certain conditions, with the
power supply plugged in to the power supply,
the power supply can be shorted by foreign
nature such as, but not limited to, grinding dust,
metal chips, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away
from power supply cavities.
• Always unplug the power supply from the power
supply when not in use. Unplug power supply
before attempting to clean. Clean only with
• DO NOT attempt to charge the product with any
power supplys other than the one provided with
your product. The power supply and integrated
together.
• The power supply provided with your laser is not
intended for any uses other than charging the
Fatmax laser. Any other uses may result in risk
• Store power supply out of reach of children.
• Do not expose power supply to rain or snow.
• Pull by plug rather than cord when disconnecting
power supply. This will reduce risk of damage to
electric plug and cord.
• Do not place any object on top of power supply
that might result in excessive internal heat. Place
heat source.
• Do not operate power supply with damaged
cord or plug.
• Do not operate power supply if it has received
damaged in any way. Take it to an authorized
service center.
• Do not disassemble power supply; take it to
an authorized service center if service or repair
is required.
• The power supply is designed to operate on
• Do not attempt to use it on any other voltage.
• Refer to Battery Safety Manual for additional
instructions.
Charging Procedure
outlet before connecting to laser unit.
2. Insert the charging cable into the charging port
on the rear of the laser unit.
NOTE:
left idle for extended periods of time. The product may
need to be recharged before use.
The power supply may become warm to touch while
battery pack after use, avoid placing the power supply
If the internal battery does not charge properly:
a. Check operation of receptacle by plugging in
switch which turns power off when you turn out
the lights;
where the surrounding air temperature is
d. If charging problems persist, take the tool, and
power supply to your local service center.