Operation Manual
User Manual
GB
• Do not freeze or immerse power supply in water
or any other liquid.
WARNING: Shock hazard. Don’t allow any liquid
to get inside power supply. Electric shock may
result.
CAUTION:
supply or any reason. The product has no user
serviceable parts inside.
Laser Tool
•
•
the unlocked position. (Fig B #3)
• The laser tool must then be positioned in its
•
repeatedly and cycling through the options
shown in Figure D.
Mounting on Accessories
•
easily disturbed and near the central location of
the area to be measured.
• Set up the accessory as required. Adjust
positioning to be sure accessory base is near
horizontal (within laser tools compensation
range).
• Mount the laser tool to the accessory using the
appropriate fastening method to be used with
CAUTION:
• Do not leave the laser tool unattended
on an accessory without fully tightening
the fastening screw. Failing to do so may
lead to the laser tool falling and sustaining
possible damage.
NOTE:
• It is best practice to always support laser
tool with one hand when placing or
removing laser tool from an accessory.
•
the fastener, align laser tool, and then
fully tighten.
NOTE:
• Before operating the laser tool always be sure to
check the laser tool for accuracy.
• Laser tool will indicate when it is out of
compensation range. Reference LED Descriptions.
Reposition laser tool to be closer to level.
• When not in use, please be sure to power OFF
the laser tool by placing the pendulum lock in the
locked position.
Power
•
transport lock to the unlocked position.(Fig B #3)
• To turn the laser OFF,
transport lock to the locked position.
•
repeatedly and cycling through the options
shown in Figure D.
Modes
B
)
• The laser will be OFF and the pendulum
locked.
B
)
• The pendulum lock on the laser tool will be
• The lasers are designed to self-level. If the
laser has been tilted > 4° then it cannot
level surface.