Use and Care Manual

STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
No part of this publication can be printed or copied without written permission.
14 of 16 Rev. 1/2011
Models: G2250S & G3250S
Troubleshooting
Symptom: Potential Causes Solution
Engine won't start Fuel valve off/out of fuel Fill tank with fuel and turn fuel valve on
Engine Switch in off position Turn engine switch to on position
Spark arrestor clogged Remove spark arrestor, clean and replace.
Cold engine needs to be primed Press primer bulb 3 to 5 times.
Oil level too low
Fill oil to top of opening with recommended
grade of oil.
Fuel filter is dirty
Check for fuel flow to carburetor by remov-
ing drain screw. Clean or replace fuel filter.
Fuel is contaminated
Drain fuel tank and carburetor. Replace or
clean filter and carburetor float bowl. Fill
tank with clean fuel.
Spark plug boot off/loose Press spark plug boot firmly on spark plug.
Spark plug fouled or failed Remove spark plug, clean or replace
Carburetor clogged
Remove float bowl and clean components
and jets. Replace carburetor if varnish or
gum has accumulated from improper stor-
age.
Recoil is hard to pull Spark arrestor clogged Remove, clean and replace.
Valve clearance too large
Rest exhaust valve clearance to .008", call
customer help line.
Engine starts, but then shuts off
after running for short time
Remove/Clean spark arrestor Remove, clean and replace.
Out of fuel Fill tank with fuel and turn fuel valve on
Spark plug fouled or failed Remove spark plug, clean or replace
Engine runs: rough/vibrating/
oscillating
Remove/Clean spark arrestor Remove, clean and replace.
Over loading generator Disconnect some appliances
Air filter is dirty Clean air filter
Fuel filter is dirty
Check for fuel flow to carburetor by remov-
ing drain screw. Clean or replace fuel filter.
Fuel is contaminated
Drain fuel tank and carburetor. Replace or
clean filter and carburetor float bowl. Fill
tank with clean fuel.