Assembly Instruction

FILLER LEAVES should be kept in protective cloth bags (provided) and
stored FLAT when not in use. Remove FILLER LEAVES before moving
the TABLE.
4. FILLER STORAGE:
2. INSTALL FILLERS:
FILLER
LEAVES
LEAF
SUPPORTS
Move all Chairs away from the
TABLE, and extend all LEAF
SUPPORTS.
1. PREPARE FOR ASSEMBLY:
CAUTION:
(3) OR MORE PERSONS
RECOMMENDED FOR
ASSEMBLY!
CAREFULLY READ
AND UNDERSTAND ALL
INSTRUCTIONS
BEFORE PROCEEDING!
CATCH
SASH
LOCK
LEVELER
SCREWS
FLAT TIP
SCREW
DRIVER
NOTE: Your furniture may have different design features than those shown in the drawing.
A-1027
The underside of each FILLER LEAF is marked with numbers, to indicate how the
FILLER LEAVES should be positioned on the TABLE. Install the FILLER LEAVES in
sequence, beginning with Leaf "1-2", then "2-3", and so on.
The number on each LEAF should be aligned with the corresponding number on the
LEAF positioned next to it. (SEE DIAGRAM) Each FILLER LEAF should rest on two LEAF SUPPORTS. The inside edge of the
FILLER LEAF should fit tightly against the edge of the TABLE TOP. As each FILLER
LEAF is installed, secure it to the other FILLER LEAVES by locking the SASH LOCK.
All FILLER LEAVES should be locked in place as they are installed. For best results,
raise LEVELLER SCREWS proximately
1
4
" while installing FILLERS.
2
2
1
1
3
3
4
4
FILLER LEAF
METAL
LEVELER
LEAF LEVELERS are located in each LEAF SUPPORT. Use a Flat Tip
Screwdriver to raise Leveler Screws approximately
1
4
" above surface of Leaf
Support or until the FILLER is level with the TOP. If FILLER surface sits
above TOP surface, adjust METAL LEVELERS by bending upward slightly.
3. LEVEL FILLERS:
FLAT TIP
SCREW
DRIVER