Assembly Instruction

CORD
ACCESS
CUTOUT
IMPORTANT!
110 Volt AC
ONLY!
BACK PANEL
RECEPTACLE:
Run Electric Wire
through Cutout in
Back Panel as
shown in sketch.
Power Cord should
be plugged into
110V AC Outlet ONLY!
NOTE: Your furniture may have different design features than those shown in the drawing.
71218-43 COMPUTER FILE DESK
A-1053
Note: If a Power Screwdriver is used, a
"low torque" setting is recommended!
CAREFULLY
READ
AND
UNDERSTAND
ALL
INSTRUCTIONS
BEFORE
PROCEEDING!
To remove ADJUSTABLE SHELF,
remove SCREWS from SHELF
SUPPORTS, then carefully lift Shelf up
and out of the ARMOIRE.
To reposition ADJUSTABLE SHELF,
insert Stem of SHELF SUPPORTS into
Holes as shown. Rest the SHELF on
the SHELF SUPPORTS, and reinstall
SCREWS.
ADJUSTABLE SHELF
SCREWDRIVER
SHELF SUPPORT
SCREW
Adjustable Glides are located under
front corners of case, as shown in the
drawing. Turn Adjustable Glide
CLOCKWISE to lower case; COUNTERCLOCKWISE to raise.
Cases should be LEVELED for proper
Door / Drawer Alignment.
FILE HANGER INSTALLATION:
1. Slide CLIPS onto DRAWER SIDES
as shown in Fig. #1 and #2 below.
2. Depress CLIP as shown in Fig. #3
below, and insert end of FILE BAR.
3. Release CLIP, securing end of FILE
BAR, as shown in Fig. #4.
4. Slide CLIPS from side to side as
necessary for proper spacing, to fit a
standard 'Letter' or 'Legal' size Hanging
File Folder. For best results, make
sure FILE BARS are parallel to each other.
DRAWER
FRONT
DRAWER
SIDE
CLIPS
DRAWER
BACK
FILE
HANGING
BARS
HANGING
FOLDER
Turn Clockwise to Lower... Turn Counterclockwise to Raise