User Manual

9
There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer to replace
any components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is dependent on a number of factors including but not limited to the
number of recharge cycles, and proper care and maintenance of the battery by the end user. Contact manufacturer for any information
you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is
required. Failure to comply with local, state and federal regulations can result in fines, or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in
injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
12 volt DC charger plug fuse replacement (optional accessory)
The fuse in the plug end of the 12 volt DC charger protects the adapter’s charging circuit. If the 120 volt AC charger operates, but the DC
charging adapter does not, then this fuse may be opened (blown).
TO REPLACE THE FUSE:
1. Unscrew the grooved end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 8 amp volt fuse.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the 12 Volt DC Charging Adapter.
TROUBLESHOOTING
Unit will not charge
• Make sure all of the unit’s functions are turned off.
• Make sure a suitable gage extension cord is properly connected to both the unit and a functioning AC outlet.
or
• Make sure the 12 volt DC charging adapter is properly connected to both the unit and a functioning DC power source.
Unit Fails to Jump-Start
• Make sure unit’s power switch is in the on position.
• Check that jump-starter has a full charge. Recharge unit if necessary.
• Make sure a proper polarity cable connection has been established.
USB Power Port will not power appliance
• Make sure the USB Charging Port Power Button is in the on position.
• Some USB-powered household electronics will not operate with this USB charging/power port. Check the manual of the corresponding
electronic device to confirm that it can be used with this type of USB charging/power port.
• Check that jump-starter has a full charge. Recharge unit if necessary.
12 Volt DC Portable Power Supply will not power appliance
• Make sure the appliance does not draw more than 5 amps
• Check that jump-starter has a full charge. Recharge unit if necessary.
LED Area Light does not come on
• Make sure the LED Area Light ON/OFF button is in the on position
• Check that jump-starter has a full charge. Recharge unit if necessary.
Portable Compressor will not inflate
• Make sure the Compressor Power Switch is in the on position.
• Make sure the nozzle connector is securely screwed on to the valve stem when attempting to inflate tires; or that the nozzle adapter is
securely screwed into the Sure Fit
®
nozzle connector and is inserted properly into the item to be inflated on all other inflatables.
• The compressor may be overheated. Press the compressor power switch to turn the compressor off. Restart after a cooling down period
of approximately 30 minutes.
• Check that jump-starter has a full charge. Recharge unit if necessary.