User Manual

8
USB POWER PORT
1. Push the USB Power Button to turn the USB Port on and the USB power indicator will light.
2. Lift up the cover of the USB Charging Port.
3. Plug the USB-powered device into the USB Charging Port and operate normally.
4. Periodically press the battery charge level pushbutton to check battery status. (When all three battery status indicators light, it
indicates a full battery. When only one red battery status indicator lights, it indicates that the unit needs to be recharged.)
Notes: This unit’s USB Power Port does not support data communication. It only provides 5 volts/500mA DC power to an external USB-powered device.
Make sure the USB Power Button is in the off position when the unit is being recharged or stored.
Some household USB-powered electronics will not operate with this unit.
12 VOLT DC PORTABLE POWER SUPPLY
This portable power source is also for use with all 12 volt DC accessories equipped with a male accessory outlet plug and are rated up to
5 amps.
1. Lift up the cover of the unit ‘s 12 volt DC outlet.
2. Insert the 12 volt DC plug from the appliance into the 12 volt accessory outlet on the unit. DO NOT EXCEED A 5 AMP LOAD.
3. Switch on the appliance and operate as usual.
4. Periodically press the battery charge level pushbutton to check battery status. (When all three battery status indicators light, it
indicates a full battery. When only one red battery status indicator lights, it indicates that the unit needs to be recharged.)
EMERGENCY AREA LIGHT
The area light is controlled by the Area Light Power Switch on top of the light. Make sure the area light is turned off when the unit is
being recharged or stored.
Periodically press the battery charge level pushbutton to check battery status. (When all three battery status indicators light, it indicates a
full battery. When only one red battery status indicator lights, it indicates that the unit needs to be recharged.)
PORTABLE COMPRESSOR
The built-in 12 volt DC compressor is the ultimate compressor for all vehicle tires, trailer tires and recreational inflatables. The compressor
hose with tire fitting is stored in a retaining channel on the back of the unit. The On/Off Switch is located on the rear of the unit under
the air pressure gauge. The compressor can operate long enough to fill up to 3 average sized tires before the battery must be recharged.
The compressor may be used by removing the air hose from the storage compartment and if required, fitting an appropriate nozzle to the
air hose. Return hose to the storage compartment after use.
Inflating Tires or Products With Valve Stems
1. Screw the Sure Fit
®
nozzle onto the valve stem. Do not overtighten.
2. Turn on the Compressor Power Switch.
3. Check pressure with the pressure gauge.
4. When desired pressure is reached, turn off the Compressor Power Switch.
5. Unscrew and remove the Sure Fit
®
nozzle from the valve stem.
6. Allow the unit to cool before storing away.
7. Store the compressor hose and nozzle in the storage compartment.
Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of the nozzle adapter.
1. Screw the adapter into the Sure Fit
®
nozzle. Do not overtighten.
2. Insert the adapter into item to be inflated.
3. Turn on the Compressor Power Switch — inflate to desired pressure or fullness.
IMPORTANT NOTE: Small items such as volleyballs, footballs, etc. inflate very rapidly. Do not over-inflate.
4. When desired pressure is reached, turn off the Compressor Power Switch.
5. Disconnect the adapter from the inflated item.
6. Unscrew and remove the adapter from the Sure Fit
®
nozzle.
7. Allow the unit to cool before storing away.
8. Store the compressor hose, nozzle and adapter in the storage compartment.
Recharge this unit fully after each use
WARNING: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Follow all safety instructions found in the “Specific
Safety Instructions For Compressors” section of this instruction manual.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is not in use, we
recommend that the battery is charged at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the unit with a soft cloth moistened with a mild
solution of water and detergent.