lismore-sf-nb-eco-manual

FLOOR PROTECTION

When installing this heater on a combustible floor, a

floor protector consisting of a layer of non com-

bustible material at least 310mm thick covered with

“1/8 sheet metal” is required to cover the area under

the heater and extend at least 460mm at the front,

100mm to the side & 280mm from the rear. This will

provide protection from sparks and embers which

may fall out from the door when stoking on refu-

elling. See Fig.13.

STOVE DIMENSIONS

Fig14

Fig15

WARNING: DO NOT OBSTRUCT PRIMARY

AIR SUPPLY TO THE STOVE

Note: Dimensions stated are in millimetres unless oth-

erwise stated and may be subject to a slight +/- variation.

COMMISSIONING AND HANDOVER

On completion of the installation allow a suitable

period of time for any fire cement and mortar to dry

out, when a small fire may be lit and checked to

ensure the smoke and fumes are taken from the

stove up the chimney and emitted safely to the

atmosphere. Do not run at full output for at least

24 hours.

Ensure that the operating instructions for the stove

are left with the customer. Ensure to advise the cus-

tomer on the correct use of the appliance with the

fuels likely to be used on the stove and warn them to

use only the recommended fuels for the stove.

Fig.13