Use and Care Manual

Rev: Feb2011
8 of 18
®
STANLEY Electric Pressure Washers
PREPARATION & ASSEMBLY - Model P1450S, P1450S-CAN, P1600S, P1600S-BB, P1600S-CAN
Assembly Time: 5 minutes
Tools Required: 17mm or Adjustable Wrench
Surface Preparation
 Before starting any cleaning task, it is important to inspect the area
for objects which could create a hazard.
 Remove any objects from the work area which could be tripped
over, such as toys or outdoor furniture.
 Ensure that all doors and windows are closed tightly.
Step 1
 Remove or peel off blue protective film on the front of the pressure
washer and on the wands (if applicable). Also, remove any bubble
wrap. Discard blue protective film and bubble wrap.
Step 2
 Attach the Quick Connect Inlet coupling to water supply inlet on
pressure washer, as shown in Figure below.
Step 3
 Attach Wand Bracket to the unit as shown in Figure below.
Step 4
 Attach High Pressure Hose to Main Unit as shown in Figure below.
Step 5
 Attach other end of High Pressure Hose to Gun as shown in Figure
below. Fasten tightly with 17mm wrench to avoid leakage.
Step 7
 Attach the hose holder strap to the side of the unit as shown in
Figure below.
Step 6
 Attach Shoulder Strap to the Strap Bracket as shown in Figure
below.
For Operating Instructions, proceed to page 9.