Use and Care Manual

9 of 18
®
STANLEY Electric Pressure Washers
Rev: Feb2011
Step 3
 Attach the gun/wand holder as shown in Figure below.
Step 4
 Attach the soap/detergent bracket, bottle, siphon hose, as shown
in Figure below.
Step 2
 Attach the Quick Connect Inlet coupling to water supply inlet on
pressure washer as shown in Figure below.
Step 6
 Attach the straight coupler end of the extension hose into the hose
reel inlet as shown in Figure below. Fasten tightly to avoid
leakage.
PREPARATION & ASSEMBLY - Model P1750S, P1750S-CAN, P1800S, P1800S-BB, P1800S-CAN
Step 7
 Attach High Pressure Hose to Gun as shown in Figure below.
Fasten tightly with 17mm wrench to avoid leakage.
Step 8
 Attach foot bracket as shown in Figure below.
Step 5
 Attach the L-shape coupler end of the extension hose (F) into the
water outlet as shown in Figure below. Fasten tightly to avoid
leakage.
Assembly Time: 5 minutes
Tools Required: 17mm or Adjustable Wrench
Surface Preparation
 Before starting any cleaning task, it is important to inspect the area
for objects which could create a hazard.
 Remove any objects from the work area which could be tripped
over, such as toys or outdoor furniture.
 Ensure that all doors and windows are closed tightly.
Step 1
 Remove or peel off blue protective film on the front of the pressure
washer and on the wands (if applicable). Also, remove any bubble
wrap. Discard blue protective film and bubble wrap.
For Operating Instructions, proceed to page 9.