Installation Guide

OPERATING INSTRUCTIONS

CARE AND MAINTENANCE

Storage

• When your pressure washing session has been

completed, turn off the power switch located on

the front of the power washer. Unplug the power

cord from the outlet. Turn off the water supply. Pull

the trigger on the spray gun 2-3 times to drain out

the excess water and to release any remaining water

pressure. Disconnect the garden hose adapter from

the water inlet. DO NOT allow the power washer to

run with no water flowing through it.

• Remove detergent bottle and clean completely.

Residual chemical will stick to the container and can

cause the detergent injector to clog and not function

properly.

• Remove high pressure hose from spray gun.

• Remove lance from the gun. Place the gun in the

holder on the side. Lances are placed into any of the

slots in the back of the unit. Make sure to discard any

remaining detergent from the bottle. Flush the bottle

and nozzle head with fresh water to prevent clogging.

• Hook the power cord around the L-shaped tabs on the

right side of the machine when facing it.

93904_16ANR029_Stanley 1900PSI ENG-FR-SP.indd 14 16/12/23 下午1:02