Full Product Manual

10
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
• Turn on water supply at the faucet to completely
open
• Make sure the “ON/OFF” switch is in the “OFF”
position. The power switch has international
symbols for ‘on’ and ‘off’: On (|) Off (O).
• Unwind the power cord completely and plug the
GFCI into a grounded 120 volt outlet.
• Release safety push trigger lock up and back into
trigger. While pointing the spray gun in a safe
direction, squeeze the trigger on the spray gun until
there is a steady stream of water, letting the water
and air out of the hose. Push trigger lock back
down to lock back into place.
OFF/0
ON/I
OFF/0
ON/I
• Turn the power switch to the “ON” (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature. Squeeze
the spray gun trigger to begin pressure washing.
• Begin power washing by squeezing the trigger on the
spray gun all the way into the handle.
• Release the spray gun trigger to stop the power
washer
• Allow the motor to come to a complete stop before
squeezing the trigger again.
• Squeezing rapidly will cause the auto start feature to
miss an on/off cycle that may prevent it from turning
on while squeezing trigger after rapid squeezing. Use
slow deliberate trigger pulls to avoid such symptoms.
• Always test a small area to avoid chance of
damaging the surface.
93908_16ANR030_2150_ENG-FR-SP.indd 10 16/12/14 下午5:49