6 Gal (22.7 Liter) WET/D RY VACUUM OWNER'S MANUAL IMPORTANT: READ THIS OPERATOR’S MANUAL BEFORE USING! Toll-free helpline for replacement parts: 1-888-899-0146 © 2016 Alton Industry Ltd.
TABLE OF CONTENTS Specifications 2 Package Contents 3 Safety Information 4 Operating Instructions 6 Care and Maintenance 9 Troubleshooting 9 Exploded View and Parts List 10 Warranty 11 PRODUCT SPECIFICATIONS Power Motor Tank Capacity Hose Power cord 120 V / 60 Hz / 7 A By-Pass, Single Stage 6 Gallon 1-1/4 in. x 6 ft. SJTW18AWG / 10 ft. Length WARNING: Use only extension cords that are rated for outdoor use.
PACKAGE CONTENTS 1 2 7 3 4 5 6 8 D C B A H E G F I Part Description Qty Part Description Part No.
SAFETY INFORMATION IMPORTANT SAFETY INSTRUCTIONS & GROUNDING INSTRUCTIONS When using an electrical appliance, basic precautions should be always followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. ATTENTION! Read all safety rules carefully before attempting to operate. Retain for future reference. DANGER! Never operate this unit when flammable materials or vapors are present because electrical devices produce arcs or sparks that can cause a fire or explosion.
SAFETY INFORMATION 24. This appliance is provided with double insulation. Use only identical replacement parts. See instructions for servicing double insulated appliances. 25. Unplug before connecting the hose, nozzle and the like. WARNING! SERVICING OF DOUBLE-INSULATED WET/DRY VAC In a double-insulated Wet/Dry Vac, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added.
OPERATING INSTRUCTIONS UNPACKING & SET-UP SUMMARY 1. Pull lid latches in an outward motion, remove power head and some accessories that may have been shipped in the tank. 2. Attach the casters according to the instruction in this manual. 3. Before replacing power head, refer to this manual to ensure you have the proper filters installed for your cleaning operation. 4. Replace power head, and apply pressure with thumb to each latch until it snaps tightly in place.
OPERATING INSTRUCTIONS DRY PICK-UP 1. The filter must always be in correct position to reduce the risk of leaks and possible damage to vac. Make sure that the filter is completely covering the filter cage. Make sure there are no gaps between the filter and the lid. (See illustration). It is very important to assemble the filter to the cage without allowing any possible leaks or tears. Any leaks will allow the picked up debris to be blown out of the blowing port and back into the surrounding environment. 2.
OPERATING INSTRUCTIONS EMPTY THE TANK WARNING: To reduce the risk of injury from accidental starting, unplug power cord before emptying the dust tank. 1. Remove the power head assembly of the wet/dry vac by pulling outward on the lid clips located on each side of the vac. Lift off the power head assembly. Dump the tank contents into the proper waste disposal container. BLOWING OPERATION WARNING: Always wear safety eyewear complying with ANSI Z87.1 in USA or CSA Z94.3 in Canada when using as a blower.
CARE AND MAINTENANCE FILTER REPLACEMENT WARNING: To reduce the risk of injury from accidental starting, unplug power cord before changing or cleaning filter. Your filter should be cleaned often to maintain peak vac performance. IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the reusable filter before using the vac for dry pickups and always reinstall the foam filter before using the vac for wet pickups. IMPORTANT: After cleaning, check the filter for tears or small holes.
EXPLODED VIEW / PARTS LIST PART DESCRIPTION QTY PART DESCRIPTION QTY 1 Handle 1 8 Middle Frame 1 2 On/off Switch 1 9 Motor Bottom Support 1 3 Top Cover 1 10 Dust Tank 1 4 Thermal Baffle 1 11 Vacuum Port 1 5 Motor 1 12 Caster Dolly 1 6 Power Cord 1 13 Caster 4 7 Lid Latches 2 10
WARRANTY Alton Industry Ltd. Group 1 year Limited Warranty This warranty covers any defects in materials or workmanship of the enclosed product. Alton Industry Ltd. Group will repair or replace any defective materials due to craftsmanship of the product. This warranty does not cover any problem caused by misuse, abuse, accidents or acts of God, such as floods or hurricanes. Consequential and incidental damages are not covered under this warranty.
Stanley® and are trademarks of Stanley Black & Decker, Inc., or its affiliates and are used under license by Alton Industry Ltd. Group Stanley Black & Decker, Inc., ©2016 The Stanley Black & Decker, Inc. New Britain, CT 06053 U.S.A http://www.stanleyblackanddecker.
