SL5HS x 2M LITHIUM-ION LED SPOTLIGHT INSTRUCTION MANUAL 2M LINTERNA LED DE LITIO-ION MANUAL DE INSTRUCCIÓN English page 3 Español pagina 9 SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. CONSERVE ESTE MANUAL PARA FUTURAS CONSULTAS. © 2014 Baccus Global LLC Boca Raton, FL 33432 (877) 571-2391 BC 16 SL5HS_ManualENSP_061814.
FEATURES CARACTERÍSTICAS 1 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
• Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
• Lift the protective cover located on the back of the unit and connect a standard North American 120 volt AC extension cord to the built-in 120 Volt AC Charger. • Insert the plug end into a (powered) standard North American 120 volt 60Hz outlet. • Charge until the battery/charge status LED indicator lights green (approximately 6 hours). Charging/recharging using the 12 Volt DC Adapter (optional accessory) • Make sure the spotlight is off.
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired in the following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer’s option. Proof of purchase may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an exchange (provided that the store is a participating retailer).
Cables de extensión • Cuando opere la herramienta al aire libre, utilice solamente cables prolongadores diseñados para su uso al aire libre o marcados como tales. • Asegúrese de que el cable de extensión esté en buenas condiciones. Cuando utilice un cable de extensión, cerciórese de que tenga la capacidad para conducir la corriente que su producto exige. Un cable de menor capacidad provocará una disminución en el voltaje de la línea, lo cual producirá una pérdida de potencia y sobrecalentamiento.
ADVERTENCIA: Nunca intente utilizar los métodos de carga de la CA y de la CC al mismo tiempo. PRECAUCIÓN: PARA REDUCIR EL RIESGO DE DAÑOS A LA PROPIEDAD: • Nunca coloque la luz hacia abajo en cualquier superficie cuando se carga. • Si no se mantiene la batería cargada puede causar daños permanentes y resultar en un pobre rendimiento. Carga/recarga con el cargador de 120 voltios CA incorporado y un cable de extensión estándar para uso doméstico (no incluido) • Asegúrese que la linterna está apagado.
La unidad no funcionará en el modo de cable 1. Compruebe la conexión al puerto de carga/ de alimentación de 12 voltios CC. 2. Compruebe la conexión a la fuente de alimentación de CC. 3. Confirmar que es un CC funcionamiento actual. 4. Compruebe el fusible del en el adaptador de 12 voltios CC no esté fundido. La unidad no funciona 1. La unidad puede haber apagado para proteger la batería se recaliente después de un largo período de operación o de carga / recarga.