Use and Care Manual

NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO

A POWER SOURCE

Operation

1. Position the fan heater so that it stands upright on a

firm, level surface, and at a safe distance from wet

environments and flammable objects.

2. Set the Thermostat Control Dial to H.

3. Connect the fan heater to the proper electrical power.

4. The fan heater will switch on when the Function

Control Dial is set to one of the four power settings.

5. When using the heater for the first time, you may

notice a slight emission of smoke. This is normal

and will stop after a short time. The heating element

was coated with a layer of protective oil during

production. The smoke is caused by the leftover oil

as it is heated.

Automatic Overheat Safety Control

– This heater is equipped with safety internal heat

limiting thermostat and overheat protection circuit.

When a potential overheat temperature is reached,

the system will automatically shut off the heater.

Thermostat Instructions

– Set the Thermostat Control to H and let the heater

operate with full power input. When the room

temperature reaches the required value, turn the

thermostat to the left until it switches off.

– The thermostat will then switch on and off

automatically to control the room temperature

according to the preset value and keep the room

temperature constant.

Setting Function

Unit is Off

Fan Runs - No heating

Fan Runs - Low Heat

Fan Runs - High Heat