STSJ0600 English(Original) Page 4
(Original instructions) ENGLISH FIG. A 3 1 2 4 9 5 6 7 8 FIG. B FIG. C 10 12 11 FIG. D FIG.
(Original instructions) FIG. F ENGLISH FIG. G 5 15 FIG. H 7 FIG.
ENGLISH (Original instructions) Technical Data SPECIFICATIONS STSJ0600 Power 600W Voltage 220-240V Frequency 50/60Hz Speed Pendulum action Bevel cut Modes Cutting capacity 800 - 3000 /min 4 Stages 0-45º 3 Steel 5mm Aluminio 15mm Wood 85mm Stroke length 20mm Cord 2m DO NOT RETURN THIS PRODUCT TO THE STORE, first contact your local STANLEY Office or nearest authorized service center. b.
(Original instructions) c. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. d. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. e. Do not overreach.
ENGLISH (Original instructions) • Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control. • Keep hands away from cutting area. Never reach underneath the work piece any reason. Do not insert fingers or thumb into the vicinity of the reciprocating blade and blade clamp. Do not stabilize the saw by gripping the shoe. • Keep blades sharp.
(Original instructions) Fitting the saw blade (Fig. C) • Hold the saw blade (10) as shown, with the teeth facing forward. • Push and hold the blade clamp (11) down. • Insert the shank of the saw blade into the blade holder (12) as far as it will go. • Release the blade clamp (11). ENGLISH • Pull the shoe plate (7) forward and set the required bevel 15°, 30° and 45° indicated in the bevel angle window. • Push the shoe plate locking lever (5) back towards the saw to lock the shoe plate (7).
ENGLISH (Original instructions) • Let the blade run freely for a few seconds before starting the cut. • Apply only a gentle pressure to the tool while performing the cut. Hints For Optimum Use Sawing laminates When cutting laminates, splintering may occur which can damage the presentation surface.
(Original instructions) ENGLISH One years full warranty If your STANLEY product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, STANLEY guarantees to replace all defective parts free of charge or – at our discretion – replace the unit free of charge provided that: • The product has not been misused and has been used in accordance with the instruction manual.
90622982 01/2015
Names & Addresses for STANLEY Service Concessionaries - MIDDLE EAST & AFRICA ALGERIA: Sarl Outillage Corporation, 08 Rue Med Boudiaf - Cheraga - Algiers, Algeria. Tel: (213-21) 375130, Fax: (213-21) 369667. ANGOLA: Angoferraria, Lda., Rua Robert Shields, No. 61, Luanda, Angola, Tel: 00244-222-395837 / 222-395034, Fax: 00244-222-394790. AZERBAIJAN: Royalton Holdings Ltd. 41 Khagani St. Apt. 47 AZ 1001, Baku. Tel: (994-12) 4935544, Fax: (994-12) 5980378. BAHRAIN: Kavalani & Sons W.L.L., P.O.
