SDS

Material Safety Data Sheet
Item : Ad-Tech 236
Revision: B
Date: 02/10/2010
4. FIRST AID MEASURES:
GET MEDICAL ASSISTANCE FOR ALL CASES OF OVEREXPOSURE
5. FIRE FIGHTING MEASURES
6. ACCIDENTAL RELEASE MEASURES
7. HANDLING AND STORAGE
Hazardous Products formed
Under oxygen deficient conditions Carbon Monoxide (CO) and irritating smoke may be
produced.
Inhalation: If symptomatic, move to fresh air. Get medical attention if symptoms persist.
Skin Contact:
Immediately flush skin with large amounts of water for at least 15 minutes. DO NOT
ATTEMPT TO REMOVE MOLTEN MATERIAL. Cover affected area with a clean
dressing. Get prompt medical attention.
Eye Contact:
Immediately flush eyes with large amounts of water for at least 15 minutes. DO NOT
ATTEMPT TO REMOVE MOLTEN MATERIAL. Get prompt medical attention.
Extinguishing Agents:
Water spray, dry chemicals.
Special Firefighting
Procedures:
Wear self-contained breathing apparatus and protective clothing.
Ingestion:
First aid is normally not required.Do not induce vomiting unless instructed to do so by
medical personnel. Give victim two glasses of water. Never give anything by mouth to an
unconscious person. Get prompt medical attention.
Unusual Fire or Explosion
Hazards:
Not applicable.
Sweep or scoop up and remove.
STORAGE TEMPERATUER (°C)： Ambient.
TRANSPORT TMEPERATURE (°C)： Ambient.
STIRAGE / TRANSPORT PRESSURE ( Kpa )：Atmospheric.
PERSONAL PRECAUTIONARY MEASURES：No special precautionary measure should be needed under
anticipated conditions of use.
PREVENTION OF FIRE AND EXPLOSION：Keep from contact with oxidizing materials.
HANDLING: Avoid skin contact with hot material. Keep out of the reach of children.
STORAGE: Store away from heat. store in tightly closed vessels and keep in a cool, and dark, well-ventilated storage
at temperature between 5℃and to 38℃。