User Manual

12
13
PIC. 7
The configuration of tools and accessories can be varied to
suit your particular requirements. A basic recommended set
up is shown in Pic. 7.
When you have finished using your air compressor
follow these simple steps;
1. Turn your air compressor OFF, using the ON/OFF
switch.
2. Turn the power point OFF and disconnect the
power lead.
3. Disconnect your air tools and air hose.
4. Clean your air hose and air tools.
5. Store your air hose and air tools in a secure
well ventilated cabinet.
6. Slowly open the tank drain tap, see page 16.
This allows excess air and moisture, water, to vent.
7. Leave the tank drain tap open. This allows any
moisture to drain while the air compressor is stored.
NOTE: Use of a water trap may be of benefit to ensure no
water or moisture reaches your air tool.
Not supplied, purchased separately.
IMPORTANT
Pumping starts at (minimum) 115PSI and stops at
(maximum) 145PSI. Once the initial pump up stage
has finished you can use the compressor.
This compressor has a maximum pressure of 10 bar.
Always regulate the outlet air pressure to match your
air tool.
Different air tools require different operating
pressures. Always check with the air tool
manufacturer if unsure.