Installation Guide

14 15
Adding Lubricating Oil
Always use clean fresh oil as specified on page 9. Incorrect
or old oil can cause the pressure washer to run rough and
damage the motor; this will not be covered by warranty.
1. Ensure that engine is OFF when filling oil.
2. Remove oil plug, see Pic. 10A.
3. Use oil as detailed on page 9 (SAE 30W or SAE 15W-40
4 Stroke Motor Oil).
4. Ensure pressure washer is level when filling with oil.
DO NOT TIP / USE A FUNNEL (Not Supplied).
5. Only fill oil to the top of the thread, Pic. 10B.
6. Ensure that the oil filler cap is screwed on tightly before
attempting to start the pressure washer.
Warning: Over filling the oil can damage the pressure
washer, this damage will not be covered under warranty.
OIL
LEVEL
PIC. 10B
DETERGENT USE
To use the detergent function you will need to use the
detergent bottle, Pic. 11.
You do not need to change the nozzle, however you will
need to rotate it to the wide low pressure setting.
DETERGENT NOZZLE SETTING
While holding the gun, rotate the nozzle to the left,
see Pic. 5, page 11. The water spray pattern will change
to a wide pattern. It will now suck up detergent from the
detergent bottle, to fill see Pic. 11.
NOTE: After using the detergent setting always clean the
bottle and nozzle with clean water, see section Detergent
Bottle.
DETERGENT BOTTLE (PIC. 11)
This pressure washer comes with a detergent bottle. Install
as per instructions on page 11, Pic. 3.
To fill;
1. Lift detergent bottle lid and remove both lid and tube.
2. Fill detergent bottle with an eco friendly, PH neutral,
cleaner.
3. Fit tube and lid to the detergent bottle and ensure lid is
fully fitted.
To clean bottle and nozzle;
1. Lift detergent bottle lid and remove both lid and tube.
2. Remove detergent bottle from holder and drain excess/
left over cleaner back into the main container.
3. Rinse the detergent bottle fully and fill about ½ way
with clean water.
4. Fit back into holder.
5. Fit tube and lid to the detergent bottle and ensure lid is
fully fitted.
6. Now use the detergent setting on the nozzle and allow
the clean water to rinse the tubes and pump.
PIC. 11
PIC. 10A