PETROL PRESSURE WASHER 4HP 2500PSI SXPW4011S 03596 02/19 MODEL NO.
SUGGESTED APPLICATIONS CONTENTS These are some suggested applications where you could use your pressure washer: • Concrete driveway • Paved area • Car • Motorbike • Truck • Wall • Garden feature Section Page Contents 2 Suggested Applications 2 Introduction 3 Warranty 3–4 General Safety Instructions 5–7 Specific Safety Instructions 8 Fuel & Oil Information 9 Components and Controls 10 Assembly Instructions 11 – 12 Operating Instructions 13 – 16 Cleaning Tips 17 Maintenance 18 – 20
INTRODUCTION What is covered. • Manufacturing fault or defect. Dear Customer, Thank you for purchasing this pressure washer which has passed through our extensive quality assurance processes. Every care has been taken to ensure that it reaches you in perfect condition. However, in the unlikely event that you should experience a problem, or if you require any assistance, please do not hesitate to contact us; How to claim under this warranty. • Call customer service.
COMPLETE WARRANTY STATEMENT – PRESSURE WASHER If a warranty fault is found, the freight cost will be credited to the owner. If no fault is found, the product will be returned and any costs associated with the service will be charged to the owner. Blockages caused by spider webs, insects, dirt, accumulated dust or incorrect oil are not covered by warranty. SMG reserves the right to replace or repair the appliance within the warranty period.
LUBRICATION OF ENGINE WORK AREA Your engine comes with NO oil in the sump. You will need to add engine oil, refer to pages 9 and 14 for complete details and images. Failure to do this may result in damage to the engine, pressure washer and / or injury to the user. Work areas and benches should be kept tidy. Cluttered benches and work areas can cause accidents. Floors should be kept clean and free from rubbish. Special care should be taken when the floor is slippery due to sawdust or wax.
MAINTAIN YOUR PRESSURE WASHER WITH CARE RISK OF DAMAGE Damage may occur if nozzle is used too close to appliance or surface being cleaned. Always trial test the pressure washer on an inconspicuous part of the appliance or surface. Beware poor paint and rust as the water will lift poor paint and cause rust spots to grow. Damage caused by pressure washer is not covered by warranty. When not using your pressure washer ensure the fuel choke is ‘OFF’.
PERSONAL SAFETY Do Not Over Reach Do not over reach. Keep a proper footing and maintain your balance at all times. Avoid using abnormal stances and awkward body positions. Clothing Do not wear loose clothing, jewellery or anything that could get caught in moving machinery. Stay Alert Watch what you are doing, use common sense and never operate a pressure washer when you are tired, drinking alcohol, taking drugs or if taking medication that causes drowsiness.
SPECIFIC SAFETY INSTRUCTIONS • If the pressure washer makes an unfamiliar sound or vibrates excessively, switch the pressure washer ‘OFF’ immediately. Investigate the possible cause or consult your authorised service agent. • Never use coolant in the pressure washer as damage may occur. • Never transport the pressure washer with fuel in the tank. ALWAYS empty the fuel tank. • Do not tamper or alter any parts as this may cause personal injury or damage the pressure washer.
IMPORTANT FUEL - ONLY USE UNLEADED 91 PETROL (ULP - 91RON) - NO ETHANOL Fuel tank capacity – 1.2 litres (1.2 L) Use of incorrect fuel and/or oil may damage the pressure washer and will not be covered under warranty. Do not use E10 or any type of ethanol fuel as this will damage the pressure washer and will not be covered under warranty. Do not use high octane fuels (greater than 91%) as this will damage the pressure washer and will not be covered under warranty.
PIC. 1 2 1 3 4 7 5 6 8 COMPONENTS AND CONTROLS (PIC. 1) 1. 2. 3. 4. 5. 6. 7. 8.
UNPACKING & ASSEMBLY PIC. 2 Unpacking Note: Carefully unpack your pressure washer. This pressure washer is bulky and heavy, two (2) person lift required. Dispose of all packing material in an environmentally responsible manner. Open carton, gently lift the pressure washer clear of the carton and packaging, this may require 2 people. Remove from plastic bag. Note: Plastic bags can be a danger to young children, dispose of immediately. Always dispose of packaging in a responsible manner.
Pressure Hose to Pump Connection (PIC. 6) Push hose fitting into the pump socket and tighten the nut fully. Note: Do not cross thread the nut as this is not covered under warranty Note: Do not allow the high pressure hose to touch the muffler, as any damage will not be covered under warranty. PIC. 6 Pressure Hose to Gun Connection (PIC. 7) Screw hose fitting fully into the gun socket. To remove the hose from the gun the process is reversed, unscrew hose fitting from the gun and remove the hose. PIC.
OPERATING INSTRUCTIONS Pre - Operation Preparation Note: If unit has previously been used, the motor, muffler and exhaust may still be hot enough to burn. Always exercise caution when checking the pressure washer. 1. Check that the fuel/engine switch is OFF. 2. Check that the spark plug lead is firmly attached to the top of the spark plug. 3. Holding on to the cage gently rock the pressure washer and listen for any noise which may indicate loose items.
Adding Lubricating Oil Always use clean fresh oil as specified on page 9. Incorrect or old oil can cause the pressure washer to run rough and damage the motor; this will not be covered by warranty. 1. Ensure that engine is OFF when filling oil. 2. Remove oil plug, see Pic. 10A. 3. Use oil as detailed on page 9 (SAE 30W or SAE 15W-40 4 Stroke Motor Oil). 4. Ensure pressure washer is level when filling with oil. DO NOT TIP / USE A FUNNEL (Not Supplied). 5. Only fill oil to the top of the thread, Pic. 10B. 6.
STARTING YOUR PRESSURE WASHER PIC. 12 1. Check oil level. 2. Check and fill fuel. 3. Connect garden hose to cold water source. Do not turn on! 4. Connect garden hose to garden connection on pump. 5. Select position of nozzle, see page 11. 6. If using detergent fill and select bottle refer page 14, Pic. 11. 7. Turn choke to start by sliding the choke lever to the LEFT, Pic 12. 8. Turn fuel on by rotating tap to the left till vertical, Pic 13. 9. Push engine switch to “1”, refer Pic. 14. 10.
TAKING A BREAK DURING USE CLEANING If taking a break of more than 2 minutes during use you must turn the pressure cleaner off. Refer page 15 for how to do this. Damage will be caused if the pressure washer is left running while the trigger is off and no water coming out for more than 2 minutes. Damaged caused will not be covered under warranty. Pressure washer pump may also “dump” hot water as a self preservation, when the pump temperature gets too hot during this break time.
CLEANING TIPS Cars, Boats & Motorcycles - with or without detergent Pre-rinse vehicle with fresh water. If using vehicle wash, place detergent suction tube directly into cleaning solution and apply to surface at low pressure. For best results, clean one side of vehicle at a time and always apply detergent from bottom to top, do not allow detergent to dry on surface.
MAINTENANCE INFORMATION PIC. 18 If scheduled maintenance is NOT carried out then this will void your warranty. Use the Service Log on page 23 to keep track of the regular servicing. Ensure that the authorised service agent has dated, signed and stamped this log to ensure your warranty is not void. Fuel Tank Filter (PIC. 18) The fuel tank filter should be checked every time you fill up the fuel tank. If dirty, replace.
Suction Hose Accessory ( Not included, available separately) The suction hose allows you to draw clean water directly from a bucket, lake, river or stream. The water must be fresh and clean. The length of the suction hose is 1.5m, so if required you will need to position the pressure washer closer to the clean water source. To use the suction hose; 1. Remove the garden fitting, keep safe as you will need to re-install when using the mains water and garden hose. 2.
MAINTENANCE SCHEDULE Engine Oil Used oil is a hazardous waste product and must be disposed of properly. Do not discard with household waste. Check with your local authorities, service centre, or dealer for safe disposal/recycling facilities. NOTE: If unsure how to do any of these checks please contact our service centre or an authorised service agent. NOTE: When performing any maintenance or servicing always ensure the pressure washer is stopped and turned off. Draining oil 1.
TROUBLE SHOOTING POSSIBLE CAUSE SUGGESTED FIX Engine will not start No or low fuel in the fuel tank Fill fuel tank No or low oil in sump Fill oil sump Fuel/Engine lever is OFF Turn fuel/engine lever ON Choke is set to RUN Slide choke to START Pressurised pump Turn water tap off, pull trigger to release water from pump.
PARTS DIAGRAM 1 2 4 3 User replaceable parts listed below. All other parts must be serviced/replaced by an authorised service agent. Part Description Part No. 1 Gun - trigger & lance 84 PW4011GT 2 High pressure hose 84 PW4011HPH 3 Rubber feet 84 PWRSP 4 Recoil starter 84 PW4011RS Air filter 84 PW4011RS Spark plug 84 PW4011RS Note: Gun, trigger and lance are all one code (84 PW4011GT).
This Service is to be complete within 50 hours or 3 months of purchase, which ever comes first. This Service is to be complete within 100 hours or 6 months of purchase, which ever comes first.
TECHNICAL INFORMATION Specifications Pressure washer SXPW4011S Maximum pressure 2500PSI with suction compatibility Flow rate 8L/min Water inlet pressure 0.4MPa Water inlet temp 35oC Engine 4HP 4 stroke OHV Weight 20Kg (no fuel) Fuel volume 1.
