Security Datasheet

Page 3/7
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 02.02.2023 Revision: 02.02.2023Version number 3.3 (replaces version 3.2)
Trade name: Loetlegierung Flowtin TSC
Loetlegierung Flowtin TSC305
Loetlegierung Flowtin TSC263
Loetlegierung Flowtin TSC105
Loetlegierung Flowtin TSC0807
Loetlegierung Flowtin TSC0307
Loetlegierung Fair Flowtin TSC305
(Contd. of page 2)
56.0.8
·
7.3 Specific end use(s)
No further relevant information available.
SECTION 8: Exposure controls/personal protection
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
CAS: 7440-22-4 silver
WEL (Great Britain) Long-term value: 0.1 mg/m³
IOELV (EU) Long-term value: 0.1 mg/m³
CAS: 7440-50-8 Copper, solid
WEL (Great Britain) Short-term value: 2** mg/m³
Long-term value: 0.2* 1** mg/m³
*fume **dusts and mists (as Cu)
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Appropriate engineering controls
No further data; see item 7.
·
Individual protection measures, such as personal protective equipment
·
General protective and hygienic measures:
Wash hands before breaks and at the end of work.
·
Respiratory protection:
Not necessary if room is well-ventilated.
Use suitable respiratory protective device in case of insufficient ventilation.
Filter P2
·
Hand protection
_S
Protective gloves
To avoid skin problems reduce the wearing of gloves to the required minimum.
Leather gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the
chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and
varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the
glove material can not be calculated in advance and has therefore to be checked prior to the application.
·
Penetration time of glove material
The determined penetration times according to EN 16523-1:2015 are not performed under practical conditions.
Therefore a maximum wearing time, which corresponds to 50% of the penetration time, is recommended.
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
Eye/face protection
Safety glasses
GB
(Contd. on page 4)