Manualshelf

Datasheet

ManualsBrandsStannol ManualsSolderSolder Wire KS115 217°C 0.5mm
12
EU-Material-safety-data-sheet according to 91/155/EWG
Page: 1(2)
Trade-name: Solder-wire KS115 ECOLOY ® TSC
Date of issue: 22.09.2005 Revised: 25/05/2007
1. Chemical Identification
Trade-name:
Solder wire KS115; ECOLOY ® TSC
Manufacturer:
Stannol GmbH
Oskarstr.3-7
42283 Wuppertal
Phone.: 0202 / 5850 sec.phone:-0202 / 585119
Phone: 0202 / 585118
2. Composition/Information of Ingredients
Chemical characteristic: Alloy Tin-Silver-Copper with max. 3,5% rosin (halogen activated)
Ingredients
Proportion CAS-No. Symbols Risk-Phrases Chemical name
remainder 7440-31-5 Tin
3,6-4,0% 7440-22-4 Silver
0,6-0,8% 7440-50-8 Copper
<3,5% Modified rosin
3. Hazards Identification:
Not a composition for the purposes of the Dangerous Substances Regulations, but nevertheless observe items 4-16
4. First Aid Measures:
General : If casualty is unconscious but breathing, place in the recovery position. If breathing has stopped
apply artificial resuscitation or give oxygen by mask
Inhalation Remove patient to fresh air. If irritation resists, obtain medical attention.
Skin Contact : If any skin irritation develops seek medical attention
Eye Contact:
Flush immediately with plenty of water. In cases where spitting flux has entered the eye seek
medical attention.
Ingestion: seek medical attention.
Hints for doctors
Inhalation of the flux fumes given off at soldering temperatures will irritate the nose, throat and
respiratory system. Repeated or prolonged exposure to flux fumes may cause shortness of
breath and cough.
.
Treatment: Decontamination, symptomatic treatment.
General : If casualty is unconscious but breathing, place in the recovery position. If breathing has stopped
apply artificial resuscitation or give oxygen by mask
Inhalation Remove patient to fresh air. If irritation resists, obtain medical attention.
Skin Contact : If any skin irritation develops seek medical attention
5. Fire Fighting Measures
Extinguishing Media: Use extinguishing media appropriate to surrounding fire con
Special Fire-fighting Procedures: Wear self-contained breathing apparatus and protective clothing to prevent contact with skin
and eyes.
6. Accidental Release Measures:
Pick up and place in appropriate container
7. Handling and Storage:
The fumes produced during soldering should be extracted away from the breathing zone of the operators. Ensure the area is well
ventilated. Wash hands with soap and warm water after handling, particularly before eating, drinking or smoking. The product should
be stored in a cool, dry area.

Summary of content (2 pages)