Datasheet

Technical Data Sheet
The above values are typical and represent no form of specification. The Data Sheet serves for information purposes. Any verbal or written advise is not binding for the
company, whether such information originates from the company offices or from a sales representative. This is also in respect of any protection rights of third parties, and
does not release the customer from the responsibility of verifying the products of the company for suitability of use for the intended process or purpose. Should any liability
on the part of the company arise, the company will only indemnify for loss or damage to the same extent as for defects in quality.
TDB_LD_HS10_EN.doc Page 1 of 1 Issue: 05.04.05
STANNOL GmbH
Oskarstraße 3-7 • 42283 Wuppertal • Tel. [phone] • Telefax [phone] • E-Mail [e-mail] • Web www.stannol.de
Wenn’s ums Löten geht
When it’s about soldering
Quand il s’agit du soudage
STANNOL
®
Solder Wire HS10
The electronic solder wire HS10 is a proven and reliable product of Stannol research, which was
developed to meet high quality requirements in industrial electronic production as well as for quick
rework.
Description:
STANNOL
®
solder wire HS10 is very efficient by its high activity, which results in quick spread of
solder and electrical safe residues.
STANNOL
®
solder wire HS10 is a halide activated rosin (colophony) flux.
STANNOL
®
solder wire HS10 conforms to DIN EN 29454-1 type 1.1.2. (former DIN 8511 F-SW26).
This activated rosin shows following properties:
Ø safe soldering even at low soldering temperatures
Ø solid and dry residues, pin testable
Ø fast soldering, high spread speed
Ø high reliability
Application:
STANNOL
®
solder wire HS10 can be used for hand and robot soldering in electronics and
electrical assembly, audio devices and telecommunication. Flux residues can remain on surfaces
without cleaning. If cleaning is necessary for optical or technical reasons, we recommend the use of
the cleaner STANNOL
®
Flux-Ex 200B or STANNOL
®
Flux-Ex 500.
Physical Properties and Data:
General properties STANNOL
®
solder wire HS10
Flux type:
type 1.1.2. acc. to DIN EN 29454-1 (F-SW26)
Flux content:
standard 2.5 weight % ± 0.3 %
Halide content:
0,9 %
Corrosion effect:
none, according to DIN 8516
lead-
containing:
lead-free (ECOLOY
®
Series):
S-Sn60Pb40
ECOLOY
®
TS (S-Sn96Ag4) - not patented
S-Sn60Pb38Cu2
ECOLOY
®
TSC (Sn95,5Ag3,8Cu0,7)
S-Pb60Sn40
ECOLOY
®
TC (S-Sn99Cu1) - not patented
S-Sn62Pb36Ag2
ECOLOY
®
TSC305 (Sn96,5Ag3,0Cu0,5)
Standard alloys
acc. to DIN EN 29453
ECOLOY
®
TSC263 (Sn97,1Ag2,6Cu0,3) - not patented
Available diameters:
from 0.3 mm
Available reel sizes:
250 g, 500 g, 1 kg
Other alloys, diameters flux contents or reel sizes are available on request.