RM.402 Professional DJ Mixer OWNER’S MANUAL STANTON MAGNETICS, Inc. information@stantondj.com © 2004 Stanton Magnetics, Inc.
Troubleshooting Problem / Symptom Sound is distorted Phono Input I hear hum. I hear feedback Possible Cause/ Solution Only plug turntables into this input, do not plug in CD players or other Line Level sources. Turn down the INPUT GAIN CONTROL Make sure you are using good shielded audio cables. Some less expensive audio cables can be susceptible to hum and interference. Keep your audio cables away from AC power cables and AC transformers.
Troubleshooting Please read carefully before use of this product failure to follow the instructions printed below may void warranty Problem / Symptom Possible Cause/ Solution • Follow all security advice printed on your mixer • When removing the unit's AC plug from the power source, grasp and pull the plug, NEVER the cord itself! No Sound • Avoid placing your mixer near heat sources, such as power amplifiers. • When in use, place your mixer on a stable surface, away from vibration.
Technical Specifications Welcome Frequency Response 20 Hz to 20 kHz +1 dB THD+N (Line) > 0.005 % at 1 kHz Congratulations on your choice of the Stanton RM.402 Professional DJ Mixer. You now own one of the most flexible DJ mixers ever designed. The rackmountable RM.402 offers up to three Microphone inputs, three Phono inputs and nine Line inputs—making it one of the most powerful DJ mixers around.
Making Connections Application Example Are you ready to get on the 1’s and 2’s? Let’s make sure you’ve made all the right connections… This is a typical setup you’ll find in many nightclubs: 2 turntables, 2 CD players, plus a microphone for the DJ. Here’s how you would set up your equipment with the RM.402: 1. Be sure all equipment is powered “OFF” and all of the RM.402’s Channel faders and Level knobs are at minimum volume. Mic 2 Here you can connect a microphone using a 1/4-inch cable.
Description of Functions 16. Input Selector switches: Use these to choose between the Phono, Line and Mic inputs. Making Connections Outputs 17. Talkover switch: Switch this to the “ON” position to enable Microphones 1 and 2. When moved to the “Talkover” position, the music is lowered by a preset amount when the mic is in use. Use the REC output to connect a stand-alone CD recorder, DAT recorder, or tape deck. Use the BOOTH output to connect directly to powered monitors or your monitor amp.
Description of Functions Description of Functions At this point, you’re pretty much ready to start mixing. So if you’re a know-it-all, or you’re just one of those people who like to learn by trialand-error, you are free to throw down. But if you wanna go for the gold and get your pilot’s license, take a moment and learn what each of the RM.402’s front-panel controls are about. 15 16 22 23 22 11 2 21 1 6.
