Magnetics PROFESSIONAL DUAL CD PLAYER Manual

NAMES AND FUNCTIONS

(10)Pitch Slider

Use the slider to adjust the CD pitch. Slide up to decrease the pitch, down to increase the pitch.

(11)JOG (Jog Dial)

During PLAY, the jog dial is used temporarily bending the pitch (pitch bend). When CD is paused, the jog dial is used

for frame search each segment of the dial represents a frame. Frame search is mostly used to set an accurate cue

point.

(12)B. SKIP

Use these buttons to go back to the beginning of the current track or select a previous track for playing.

(13)CUE Indicator

When in CUE mode, the CUE indicator lights.

(14)CUE (Cue Button)

Pressing the CUE button during play provides a return to the position at which play was started. If PAUSE is used

before CUE or a CUE POINT was set, that will become the cue point. Alternately pressing the Play button and the

CUE button allows the CD to be played from the same position any number of times. The CUE LED will light up from

the time the CUE button is pressed until the CD has reset to the position at which play was started. Steady lighting of

this LED indications the ready condition. The CUE button can be held down to play a CD. When you release the CUE

button it instantly returns to the CUE POINT.

(15)KEY

This button activates the KEY Correction function. This function will allow you to make adjustment to a track speed

using the pitch control without altering a track perceived tonal pitch. When KEY is on, Pitch LED is flashing; and LED

is off when KEY is off.

(16)PLAY Indicator

The PLAY indicator lights during play mode.

(17)PLAY/PAUSE Button

Use the button to start playback. Press once to start playback, once again to set the pause mode, and once more to

resume playback.

(18)F. SKIP

Use these buttons to skip to the next CD track.

(19)IN R.CUE

This allows you to set the cue point without stopping the play back. This button also sets the beginning of a seamless

loop.

(20)OUT EXIT

This button is used to set the end point of a loop. Once the end point is set, the player automatically start looping.

Press this button again to exit the loop.

(21)PITCH (Pitch Button)

Press PITCH button to switch on/off pitch.; hold the PITCH button down for more than 0.6 sec to switch pitch in +/-8%

/ +/-12% / +/-16%.

(22)CONTROL CONNECTOR

Connect this connector to the REMOTE connector on the main unit using the included control cord

(23)FADER START CONNECTOR

Via the Control socket, the respective CD-player can be remotely controlled. If you are using a mixer with fader start-

function connect the player with the Control Out-socket. Please note that these sockets must never be connected with

any voltage.

23 22 23