FULL MANUAL BELT DRIVE TURNTABLE STR8-20 WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
NAME OF PARTS 1) 2) 3) 4) 5) 6) 7) Strobe Dots Slip Mat Center Spindle Power Switch Start/Stop Button 33 Button 45 Button 8) 9) 10) 11) 12) 13) Headshell Pitch Control Slider Tonearm Arm Rest Counterweight Position For Preparing Cartridge BEFORE USE *Check following parts included in the package with the main unit: 1) Turntable platter 2) Slip mat 3) 45-rpm adaptor 4) Counterweight 5) Headshell 6) Operating instructions 7) RCA Cables with ground wire 8) Cartridge *Notes: 1) Do not connect the AC power
ASSEMBLY 1. Remove the main unit with the packing from the box and take off the packing. 2. Insert the turntable platter onto the center spindle. 3. Set the slip mat on the platter. 4. Hold the ribbon tape which is attached to the belt and loop the belt over the motor pulley. Be sure it does not twist. Ribbon tape Driving roller Drive belt 5. 6. 7. Insert the headshell into the front end of the tonearm, then turn the lock nut clockwise with the headshell firmly held horizontally.
OPERATION 1. Rotate the power dial clockwise to turn on the power, the speed indicator and the strobeilluminator will light up. 2. Place a record on the slip mat, when playing a 45rpm record with a large center hole, place the 45rpm adaptor on the center spindle. 3. Set the rotation speed (33/45) to match the record. 4. Remove the stylus protector, release the arm clamp. 5. Press the Start/Stop button, the turntable platter will start to rotate. 6. Move the tonearm over the desired groove. 7.