FULL MANUAL DIRECT DRIVE TURNTABLE STR8-30 WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
NAME OF PARTS 1 14 13 2 3 12 4 11 10 9 5 6 7 8 1) Hinge For Dust Cover 2) Strobe Dots 3) Slip Mat 4) Center Spindle 5) Power Switch 6) Start/Stop Button 7) 33 Button 8) 45 Button 9) Headshell 10) Pitch Control Slider 11) Tonearm 12) Arm Rest 13) Counterweight 14) Position For Preparing Cartridge BEFORE USE *Check following parts included in the package with the main unit: 1) Turntable platter 2) Slip mat 3) Dust cover 4) 45-rpm adaptor 5) Counterweight 6) Headshell 7) Operating instructions 8) RCA
ASSEMBLY 1. Remove the main unit with the packing from the box and take off the packing. 2. Insert the turntable platter onto the center spindle. 3. Set the slip mat on the platter. 4. Installation of cartridge: When installing a cartridge, refer to the operating instructions of that cartridge. During installation, attach the stylus protector to guard the stylus tip from damage. (1) Connect the lead wires to the cartridge terminals. The terminals of most cartridges are color coded.
OPERATION 1. Rotate the power dial clockwise to turn on the power, the speed indicator and the strobeilluminator will light up. 2. Place a record on the slip mat, when playing a 45rpm record with a large center hole, place the 45-rpm adaptor on the center spindle. 3. Set the speed to match the record. 4. Remove the stylus protector, release the arm clamp. 5. Press the Start/Stop button, the turntable platter will start to rotate. 6. Move the tonearm over the desired groove. 7.