MSDS

ManualsBrandsStar Brite ManualsCleaning22 oz. Rust Stain Remover

MATERIAL SAFETY DATA SHEET

1. Product and Company Identification

Material name

Starbrite Rust Stain Remover

Version #

Issue date

05-08-2012

Revision date

Supersedes date

Product code

892XX

Product use

Cleaner.

Manufacturer/Supplier

Star brite Distributing, Inc.

4041 SW 47th Avenue

Fort Lauderdale, FL 33314 US

Contact Person: Vincent Waclawek

(954) 587-6280

General Information:

Emergency

24-Hour Emergency: CHEMTREC: (703) 527-3887

or (800) 424-9300

2. Hazards Identification

Physical state

Liquid.

Appearance

Clear, pale yellow liquid.

Emergency overview

DANGER!

Causes eye burns. Harmful if absorbed through skin or swallowed. Combustible liquid and vapor.

OSHA regulatory status

This product is hazardous according to OSHA 29 CFR 1910.1200.

Potential health effects

Routes of exposure

Inhalation. Eye contact. Skin contact. Ingestion.

Eyes

Causes eye burns.

Skin

Harmful if absorbed through skin.

Inhalation

May cause respiratory tract irritation.

Ingestion

Harmful if swallowed.

Signs and symptoms

Contact can cause corrosive burns, corneal damage, and blindness. Symptoms of overexposure

may be headache, dizziness, tiredness, nausea and vomiting.

Potential environmental effects

The product may affect the acidity (pH-factor) in water with risk of harmful effects to aquatic

organisms.

Components CAS # Percent

3. Composition / Information on Ingredients

144-62-7 <10Oxalic acid

111-76-2 <7Ethylene glycol N-butyl ether

27176-87-0 <5Dodecylebenzene sulfonic acid

Composition comments

All concentrations are in percent by weight unless ingredient is a gas. Gas concentrations are in

percent by volume.

4. First Aid Measures

First aid procedures

Eye contact

Immediately flush with plenty of water for at least 15 minutes. If easy to do, remove contact

lenses. Call a physician or poison control center immediately. In case of irritation from airborne

exposure, move to fresh air. Get medical attention if symptoms persist.

CPH MSDS NA

1 / 7

Starbrite Rust Stain Remover CPH MSDS NA

900495 Version #: 01 Revision date: - Issue date: 05-08-2012

Summary of content (7 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET 1. Product and Company Identification Material name Starbrite Rust Stain Remover Version # 01 Issue date 05-08-2012 Revision date - Supersedes date - Product code 892XX Product use Cleaner. Manufacturer/Supplier Star brite Distributing, Inc. 4041 SW 47th Avenue Fort Lauderdale, FL 33314 US Contact Person: Vincent Waclawek General Information: Emergency (954) 587-6280 24-Hour Emergency: CHEMTREC: (703) 527-3887 or (800) 424-9300 2.
PAGE 2
Skin contact Immediately flush with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical attention immediately. Wash contaminated clothing before reuse. Destroy or thoroughly clean contaminated shoes. Inhalation If symptomatic, move to fresh air. Get medical attention if symptoms persist. Ingestion Call a physician or poison control center immediately. DO NOT induce vomiting. If victim is fully conscious, give a cupful of water.
PAGE 3
Canada. Alberta OELs (Occupational Health & Safety Code, Schedule 1, Table 2) Components Type Value Ethylene glycol N-butyl TWA 97 mg/m3 ether (111-76-2) 20 ppm Oxalic acid (144-62-7) STEL 2 mg/m3 TWA 1 mg/m3 Canada. British Columbia OELs. (Occupational Exposure Limits for Chemical Substances, Occupational Health and Safety Regulation 296/97, as amended) Type Components Value Ethylene glycol N-butyl TWA 20 ppm ether (111-76-2) Oxalic acid (144-62-7) STEL 2 mg/m3 TWA 1 mg/m3 Canada. Ontario OELs.
PAGE 4
Solubility (water) Complete. Specific gravity 1 (20°C) Flash point 152.6 °F (67 °C) Pensky-Martens Closed Cup Approximate. Flammability limits in air, upper, % by volume Not available. Flammability limits in air, lower, % by volume Not available. Auto-ignition temperature Not available. Evaporation rate < 1 (n-Butyl acetate = 1) 10. Chemical Stability & Reactivity Information Chemical stability Material is stable under normal conditions.
PAGE 5
13. Disposal Considerations Waste codes D002: Waste Corrosive material [pH <=2 or =>12.5, or corrosive to steel] Disposal instructions Must be incinerated in a suitable incineration plant holding a permit delivered by the competent authorities. Do not allow this material to drain into sewers/water supplies. Do not contaminate ponds, waterways or ditches with chemical or used container. When this product as supplied is to be discarded as waste, it may meet the definition of a RCRA waste under 40 CFR 261.
PAGE 6
Section 311/312 (40 CFR 370) No Drug Enforcement Administration (DEA) (21 CFR 1308.11-15) Not controlled Canadian regulations This product has been classified in accordance with the hazard criteria of the CPR and the MSDS contains all the information required by the CPR.
PAGE 7
16. Other Information HMIS® ratings Health: 3 Flammability: 2 Physical hazard: 0 NFPA ratings Health: 2 Flammability: 2 Instability: 0 Disclaimer The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use thereof.