User Manual

INSTALLATION INSTRUCTIONS FOR MODELS
200CF, 200CFD, 200CFQ, and 200JF
IMPORTANT: Please read all of the following instructions before installing your new strobe light. This
instruction sheet applies only to the Star models listed above.
CAUTION: All of our DC powered warning lights are polarity sensitive. These lights are polarity protected
only if the appropriate fuse is used. All wires connected to the positive terminal of the battery should be
fused at the battery for their rated load. Testing the light before this fuse is properly installed will
void the warranty on the light.
Your new Star warning light comes complete with a foam mounting gasket, three mounting screws, three
lock washers, and three rubber well nuts.
Remove the foam gasket from the shipping box. Each gasket comes furnished with three outer holes.
(NOTE: You might have to stretch the gasket to find the location of the three holes).
Place the gasket in the exact position the light is to be mounted. Using the gasket as a template, mark the
three outer holes and a hole in the center for your wires on the mounting surface. Take care to ensure that
the gasket does not move while you are marking each of the four holes.
Remove the gasket and drill a 3/8" hole in the four marked locations. CAUTION: Take care not to drill
through the headliner of the vehicle below.
Push the enclosed rubber well nuts through the three outer holes until the bottom side of the wider lip
rests on the surface of the vehicle.
Place the light on the surface of the vehicle, routing the wires through the center hole in the gasket and
then the center hole in the mounting surface. Align the three holes in the flange of the light with the three
outer holes in the gasket and the three rubber well nuts in the mounting surface. Install the three screws
through the flange and gasket, into the well nuts. Tighten until snug.
The black wire is the ground lead and should be connected to a good chassis ground.
10.
For model 200CFD or 200CFQ skip to Step 11. For the 200CF and 200JF proceed as follows:
Connect the red wire to the positive side of the power through a single-pole, two position switch (available
from Star part #SP3860-1) and a 5 Amp fuse. Skip the remaining step.
11.
For the 200CFD or 200CFQ
Low power only operation: Leave the purple wire unconnected and place a wirenut on the end.
High power only operation: Connect the purple wire to ground with the black wire.
HIGH/LOW operation: Refer to the wiring diagram on the reverse side of this sheet for proper
connections using a two-switch switch-panel available from Star. (Ask
for Part # SP3860-2H).
If you have any questions concerning this or any other Star product,
please contact our C
ustomer Service Department at (585) 226
-
9787.
ONE YEAR LIMITED WARRANTY
The manufacturer warrants each new product, under normal use, against factory defects in material and
workmanship for one year after the date of purchase. The
owner will be responsible for returning to the Service
Center any defective item(s) with the transportation costs prepaid. The manufacturer will, without charge,
repair
or replace at its option, products, or part(s), which its inspection determines to be
defective. Repaired or
replacement item(s) will be returned to the purchaser with transportation costs prepaid from the service point. A
copy of the purchaser's receipt must be returned with the defective item(s) in order to qualify for the warranty
coverage.
Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes, and/or the finish. This
warranty shall not apply to any light, which has been altered, such that in the manufacturer's judgment, the
performance or reliabi
lity has been affected, or if any damage has resulted from abnormal use or service. This
warranty does not apply to defect or damage occurring as a result of disaster, accident, abuse, misuse, lightning,
power surges, or failure to follow instructions in
any enclosed manuals. Any damage or defects occurring as a
result of any unauthorized service or repairs by unauthorized persons shall be excluded from this warranty.
There are no warranties expressed or implied (including any warranty of merchantability
or fitness), which extend this
warranty period.
The loss of use of the product, loss of time, inconvenience, commercial loss or consequential
damages, including costs of any labor, are not covered. The manufacturer reserves the right to change the desig
n of
the product without assuming any obligation to modify any product previously manufactured.
This warranty gives you specific legal rights. You might also have additional rights which may vary from state to
state. Some states do not allow limitations
on how long an implied warranty lasts. Some states do not allow the
exclusion or limitation of incidental or consequential damages. Therefore, the above limitation(s) or exclusion(s)
may not apply to you.
If you have any questions concerning this or any other product,
please contact our Customer Service Department at (585) 226-9787.
If a product must be returned for any reason, please contact our Customer Service Department
to obtain a Returned Goods Authorization Number (RGA #) before you ship the product back.
Please write the RGA # clearly on the package near the mailing label.
HIGH
CONNECT TO
+12 VDC
ON
BLACK
5 AMP
FUSE
1
2
3 3
OFFLOW
1
2
GOOD
CHASSIS
GROUND
WARNING
LIGHT
GOOD
CHASSIS
GROUND
RED
PURPLE
BLACK
FUSED RED LEAD
PURPLE
RED
BLACK
OFF
ON
SP3860-1 SWITCH PANEL (REAR VIEW) SP3860-2H SWITCH PANEL (REAR VIEW)
RED
WARNING
LIGHT
PURPLE (IF PRESENT)
GOOD
CHASSIS
GROUND
BLACK
1
3
2
CONNECT TO
+12 VDC
5 AMP
FUSE
RED
RED
GOOD
CHASSIS
GROUND
For standard ON/OFF operation make
your connections as illustrated above
For HIGH/LOW operation make
your connections as illustrated above
Please Note:
These instructions are provided as a general guideline only. Specific
mounting, wiring, and/or weather-
sealing may be necessary and are the sole
responsibility of the installer. Star Headlight & Lantern Co., Inc. assumes no
responsibility for the integrity of the installation for this or any of its products.

Summary of content (1 pages)